Skip to content
worldfires
IT · Italy · →

Chiusa Sclafani fire, July 2020 Chiusa Sclafani, Palazzo Adriano

Out · last detection 27 Jul 2020, 00:44 UTC

The fire started on 25 July 2020 in Chiusa Sclafani, Italy, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 141 hectares from satellite imagery, spread across 2 municipalities.

It is the 139th largest in Palermo since 2016 (of 179 with a page). Number 85 in Italy in 2020, of 140.

The power measured by the satellite is low (11.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
141ha
Copernicus perimeter
Duration
3days
25 Jul 2020 – 27 Jul 2020
Municipalities hit
2
municipalities
Started on
25 Jul
2020
Heat detections
18
in a single hotspot: 12 MW
Danger at start
35
High · FWI index
Average daily power
32MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 25 Jul27 Jul
27 Jul 2020

How it evolved, day by day

25 Jul 2020 · 50 MW · 6 26 Jul 2020 · 45 MW · 11 27 Jul 2020 · 1 MW · 1
25 Jul 26 Jul 27 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

29°high
42km/h · peak gust
27%lowest humidity

It had gone 9 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Chiusa Sclafani 2,530 inhabitants · 4.3 km from the centre where it started
    142 ha reached on 25 Jul
    2.5 %
  2. Palazzo Adriano 1,814 inhabitants · 5.4 km from the centre
    0 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub99 %
  • Broadleaved forest1.4 %

Natura 2000 protected area affected: 100 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
25 Jul 29.0 °C 27 % 42 km/h 0.1 mm High 35
26 Jul 27.9 °C 33 % 34 km/h 0.0 mm High 29
27 Jul 28.1 °C 27 % 34 km/h 0.0 mm High 29
28 Jul after 29.3 °C 26 % 28 km/h 0.0 mm High 26
29 Jul after 29.7 °C 33 % 27 km/h 0.0 mm High 28
30 Jul after 30.6 °C 36 % 25 km/h 0.0 mm High 27
31 Jul after 31.3 °C 30 % 31 km/h 0.0 mm High 28
1 Aug after 32.2 °C 25 % 37 km/h 0.0 mm High 35
2 Aug after 31.6 °C 26 % 28 km/h 0.0 mm High 33
3 Aug after 28.9 °C 37 % 36 km/h 0.0 mm High 32
4 Aug after 28.6 °C 35 % 46 km/h 0.0 mm High 35
5 Aug after 25.3 °C 38 % 45 km/h 0.0 mm High 34
6 Aug after 24.8 °C 43 % 42 km/h 0.0 mm High 29

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 18 Jul 2020
After · 3 Aug 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 30 July 2020 the air beside the fire reached 11 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak11 µg/m³
Days over the guideline0 days
PM1017 µg/m³
2324252627282930
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 18Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Chiusa Sclafani fire last?
Copernicus dates it between 25 July 2020 and 27 July 2020: 3 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 141 hectares (1.4 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Chiusa Sclafani (142 ha, 2.5 %); Palazzo Adriano (0 ha, 0.0 %).
Did the fire reach a town?
The fire started in Chiusa Sclafani and came within 4.3 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 29.0 °C, humidity dropped to 27 % and gusts hit 42 km/h. The fire danger index (FWI) reached 35, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 18 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.