Skip to content
worldfires
ZM · Zambia · →

Chipili fire, 5 September 2025 Chipili, Mwense

Out · last detection 10 Sept 2025, 12:13 UTC

The fire started on 5 September 2025 in Chipili, Zambia, and satellites saw it burning for 8 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,961 hectares from heat detections, spread across 2 municipalities.

It is the 363th largest in Luapula since 2016 (of 533 with a page). Number 152 in Zambia in 2025, of 271.

Burnt area
3,961ha
GWIS perimeter (Copernicus)
Duration
8days
5 Sept 2025 – 12 Sept 2025
Municipalities hit
2
districts
Started on
5 Sept
2025
Heat detections
116
in a single hotspot: 105 MW
Danger at start
49
Very high · FWI index
Energy released
1.0GW
sum of detected power

Where it burned

10 Sept 2025
HOTSPOTS BY DAY 5 Sept12 Sept

How it evolved, day by day

568910

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
50km/h · peak gust
16%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

54% of the perimeter overlaps earlier fires recorded since 2016: 217 ha in 2016, 414 ha in 2017, 232 ha in 2018, 1,106 ha in 2020, 422 ha in 2021, 77 ha in 2022, 158 ha in 2024. Part of it burned more than once, so the yearly figures add up to more than the 2,140 ha that had burned before.

What happened to each town

  1. Chipili where it started
    3,734 ha reached on 30 Aug
    0.9 %
  2. 252 ha reached on 1 Sept
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
5 Sept 29.6 °C 16 % 50 km/h 0.0 mm Very high 49
6 Sept 30.1 °C 18 % 40 km/h 0.0 mm Very high 44
7 Sept 30.6 °C 18 % 38 km/h 0.0 mm Very high 44
8 Sept 30.4 °C 18 % 35 km/h 0.0 mm Very high 43
9 Sept 30.6 °C 19 % 39 km/h 0.0 mm Very high 45
10 Sept 30.1 °C 27 % 37 km/h 0.0 mm Very high 42
11 Sept 29.1 °C 28 % 41 km/h 0.0 mm Very high 42
12 Sept 30.5 °C 23 % 35 km/h 0.0 mm Very high 39
13 Sept after 31.4 °C 20 % 36 km/h 0.0 mm Very high 43
14 Sept after 31.4 °C 23 % 29 km/h 0.0 mm Very high 39
15 Sept after 31.2 °C 21 % 32 km/h 0.0 mm Very high 39
16 Sept after 32.0 °C 17 % 31 km/h 0.0 mm Very high 42
17 Sept after 33.0 °C 16 % 32 km/h 0.0 mm Very high 45
18 Sept after 32.3 °C 14 % 43 km/h 0.0 mm Extreme 50
19 Sept after 31.4 °C 27 % 38 km/h 0.0 mm Very high 45
20 Sept after 32.1 °C 23 % 56 km/h 0.0 mm Extreme 53
21 Sept after 30.2 °C 25 % 48 km/h 0.0 mm Very high 48
22 Sept after 31.2 °C 25 % 38 km/h 0.0 mm Very high 43

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 29 Aug 2025
After · 19 Sept 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 6 September 2025 the air beside the fire reached 76 µg/m³ of PM2.5. That day averaged 44: 2.9 times the WHO daily guideline (15).

PM2.5 peak76 µg/m³
Days over the guideline13 days
PM1078 µg/m³
Optical depth1.11
3456789101112131415
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 116Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Zambia ›

Frequently asked questions

How long did the Chipili fire last?
GWIS (Copernicus) dates it between 5 September 2025 and 12 September 2025: 8 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,961 hectares (39.6 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Chipili (3,734 ha, 0.9 %); Mwense (252 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 30.6 °C, humidity dropped to 16 % and gusts hit 50 km/h. The fire danger index (FWI) reached 49, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Zambia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.