Skip to content
worldfires
TH · Thailand · –

Chiang Dao fire, 2 March 2020 เชียงดาว · Chiang Dao

Out · last detection 12 Mar 2020, 06:23 UTC

The fire started on 2 March 2020 in Chiang Dao, Thailand, and satellites saw it burning for 11 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 4,017 hectares from heat detections, spread across a single municipality.

It is the 21th largest in Chiang Mai Province since 2016 (of 319 with a page). Number 44 in Thailand in 2020, of 457.

The power measured by the satellite is low (15.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
4,017ha
GWIS perimeter (Copernicus)
Duration
11days
2 Mar 2020 – 12 Mar 2020
Municipalities hit
1
districts
Started on
2 Mar
2020
Heat detections
137
in a single hotspot: 16 MW
Danger at start
43
Very high · FWI index
Average daily power
34MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 2 Mar12 Mar
12 Mar 2020

How it evolved, day by day

2 Mar 2020 · 6 MW · 5 3 Mar 2020 · 8 MW · 1 4 Mar 2020 · 7 MW · 3 5 Mar 2020 · 2 MW · 2 6 Mar 2020 · 30 MW · 16 7 Mar 2020 · 26 MW · 16 8 Mar 2020 · 48 MW · 17 9 Mar 2020 · 54 MW · 21 10 Mar 2020 · 117 MW · 31 11 Mar 2020 · 58 MW · 22 12 Mar 2020 · 14 MW · 3
2 Mar 5 Mar 10 Mar

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
41km/h · peak gust
20%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

48% of the perimeter overlaps earlier fires recorded since 2016: 877 ha in 2016, 732 ha in 2017, 270 ha in 2018, 278 ha in 2019. Part of it burned more than once, so the yearly figures add up to more than the 1,915 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 2.5% of the area of London (40 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Chiang Dao เชียงดาว where it started
    4,103 ha reached on 2 Mar
    1.9 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area1.0 ha
Residents≈ 150

Inside the perimeter there were about 1.0 hectares of built-up land and about 150 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with 60 days without rain: 15 % of the area in Thailand

Day High Min. humidity Peak gust Rain Danger (FWI)
2 Mar 34.9 °C 21 % 34 km/h 0.0 mm Very high 43
3 Mar 33.2 °C 25 % 41 km/h 0.0 mm Very high 44
4 Mar 32.5 °C 29 % 28 km/h 0.0 mm Very high 42
5 Mar 33.7 °C 23 % 38 km/h 0.0 mm Very high 47
6 Mar 34.8 °C 21 % 36 km/h 0.0 mm Very high 45
7 Mar 35.7 °C 20 % 35 km/h 0.0 mm Very high 41
8 Mar 35.4 °C 21 % 40 km/h 0.0 mm Very high 44
9 Mar 35.6 °C 21 % 31 km/h 0.0 mm Very high 42
10 Mar 35.2 °C 22 % 29 km/h 0.0 mm Very high 39
11 Mar 36.2 °C 20 % 39 km/h 0.0 mm Extreme 50
12 Mar 36.9 °C 22 % 26 km/h 0.0 mm Very high 42
13 Mar after 37.2 °C 25 % 21 km/h 0.0 mm High 37
14 Mar after 36.1 °C 25 % 24 km/h 0.0 mm Very high 40
15 Mar after 36.7 °C 27 % 31 km/h 0.0 mm Very high 47
16 Mar after 36.0 °C 28 % 32 km/h 0.0 mm Very high 41
17 Mar after 36.6 °C 23 % 33 km/h 0.0 mm Very high 43
18 Mar after 37.4 °C 21 % 32 km/h 0.0 mm Very high 45
19 Mar after 36.3 °C 22 % 23 km/h 0.0 mm High 38
20 Mar after 35.9 °C 25 % 41 km/h 0.0 mm Very high 46
21 Mar after 35.2 °C 24 % 40 km/h 0.0 mm Very high 49
22 Mar after 33.5 °C 29 % 33 km/h 0.7 mm Very high 44

Its twins: fires that started in the same weather

It started with an FWI of 42.9, a minimum humidity of 21% and more than two months without rain. Fires in the area that started in weather like this since 2016: 33.

FWI at the start 42.9
Minimum humidity 21 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Mueang Chiang Rai fire, April 2019
6,657 ha 18 days FWI 43.3 Min. humidity 21 % 72 km away, in 2019

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

13 days
median duration
2,107 ha
median area
100 %
went past 1,000 ha
2.5 mm
rain at the end (median; 21 of 33 had it)

It was 1.9 times larger than the median of its twins and lasted 11 days, against 13 days.

Only 6 of its 33 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 12 of 33, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.5 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
41km/h · max. gust

It was considered over on 12 Mar, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 21 of 33, with a median of 2.5 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 24 Feb 2020
After · 19 Mar 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 137Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Thailand

Frequently asked questions

How long did the Chiang Dao fire last?
GWIS (Copernicus) dates it between 2 March 2020 and 12 March 2020: 11 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 4,017 hectares (40.2 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Chiang Dao (4,103 ha, 1.9 %).
What was the weather like?
During the fire the temperature reached 36.9 °C, humidity dropped to 20 % and gusts hit 41 km/h. The fire danger index (FWI) reached 50, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Thailand (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 33. Their median duration was 13 days and their median area 2,107 ha; 100 % went past 1,000 ha. Only 6 of its 33 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 12 of 33, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.5 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 199 · 191 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 199 · 191.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery; 2 polygons grouped in this page.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 137 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.