Skip to content
worldfires
MZ · Mozambique · –

Cheringoma fire, 17 October 2019 Cheringoma

Out · last detection 29 Oct 2019, 11:49 UTC

The fire started on 17 October 2019 in Cheringoma, Mozambique, and satellites saw it burning for 13 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,172 hectares from heat detections, spread across a single municipality.

It is the 134th largest in Sofala since 2016 (of 156 with a page). Number 177 in Mozambique in 2019, of 212.

Burnt area
3,172ha
GWIS perimeter (Copernicus)
Duration
13days
17 Oct 2019 – 29 Oct 2019
Municipalities hit
1
districts
Started on
17 Oct
2019
Heat detections
132
in a single hotspot: 107 MW
Danger at start
17
Moderate · FWI index
Average daily power
132MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 17 Oct29 Oct
29 Oct 2019

How it evolved, day by day

17 Oct 2019 · 17 MW · 2 18 Oct 2019 · 14 MW · 2 19 Oct 2019 · 15 MW · 4 21 Oct 2019 · 57 MW · 2 22 Oct 2019 · 45 MW · 7 24 Oct 2019 · 17 MW · 3 25 Oct 2019 · 161 MW · 25 26 Oct 2019 · 551 MW · 31 27 Oct 2019 · 76 MW · 8 28 Oct 2019 · 484 MW · 45 29 Oct 2019 · 12 MW · 3
17 Oct 21 Oct 26 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

43°high
47km/h · peak gust
12%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started.

This area had burned before

70% of the perimeter overlaps earlier fires recorded since 2016: 249 ha in 2016, 613 ha in 2017, 1,851 ha in 2018. Part of it burned more than once, so the yearly figures add up to more than the 2,223 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 2% of the area of London (32 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Cheringoma where it started
    3,189 ha reached on 17 Oct
    0.4 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.18 ha
Residents≈ 40

Inside the perimeter there were about 0.18 hectares of built-up land and about 40 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
17 Oct 28.6 °C 50 % 43 km/h 0.8 mm Moderate 17
18 Oct 29.3 °C 48 % 33 km/h 6.1 mm Very low 3
19 Oct 32.7 °C 47 % 37 km/h 6.2 mm Very low 4
20 Oct 32.0 °C 57 % 35 km/h 1.9 mm Very low 4
21 Oct 37.1 °C 33 % 29 km/h 0.0 mm Moderate 18
22 Oct 38.0 °C 33 % 47 km/h 0.0 mm High 25
23 Oct 37.3 °C 34 % 36 km/h 0.0 mm High 24
24 Oct 40.7 °C 23 % 36 km/h 0.0 mm High 31
25 Oct 41.0 °C 19 % 38 km/h 0.0 mm High 36
26 Oct 41.2 °C 20 % 38 km/h 0.0 mm High 38
27 Oct 40.9 °C 18 % 42 km/h 0.0 mm Very high 38
28 Oct 42.4 °C 12 % 45 km/h 0.0 mm Very high 47
29 Oct 42.9 °C 15 % 46 km/h 0.0 mm Extreme 50
30 Oct after 35.8 °C 37 % 46 km/h 0.3 mm High 36
31 Oct after 33.7 °C 42 % 42 km/h 0.4 mm High 32
1 Nov after 31.6 °C 45 % 50 km/h 0.6 mm High 25
2 Nov after 32.2 °C 34 % 42 km/h 0.0 mm High 28
3 Nov after 35.8 °C 25 % 40 km/h 0.0 mm High 36
4 Nov after 34.9 °C 30 % 47 km/h 0.0 mm Very high 39
5 Nov after 31.9 °C 33 % 42 km/h 0.1 mm High 35
6 Nov after 34.3 °C 32 % 43 km/h 0.0 mm High 37
7 Nov after 36.9 °C 30 % 35 km/h 0.0 mm High 36
8 Nov after 39.2 °C 28 % 39 km/h 0.1 mm Very high 39

Its twins: fires that started in the same weather

It started with an FWI of 17.1, a minimum humidity of 50% and 2 days without rain. Fires in the area that started in weather like this since 2016: 16.

FWI at the start 17.1
Minimum humidity 50 %
Days without rain 2
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Cheringoma fire, October 2017
3,080 ha 13 days FWI 22.6 Min. humidity 50 % 15 km away, in 2017

First rain (1 mm or more) after it ended: 7.7 mm on 28 Oct.

What happened to them

13 days
median duration
4,319 ha
median area
25 %
went past 10,000 ha
2.0 mm
rain at the end (median; 14 of 16 had it)

It burned an area similar to its twins (3,172 ha against a median of 4,319 ha) and lasted 13 days, against 13 days.

In 2 of 16, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
47km/h · max. gust

It was considered over on 29 Oct, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 14 of 16, with a median of 2.0 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 10 Oct 2019
After · 5 Nov 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 132Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Mozambique

Frequently asked questions

How long did the Cheringoma fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 17 October 2019 to 29 October 2019 (13 days). The perimeter dates it from 24 October 2019 to 29 October 2019.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,172 hectares (31.7 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Cheringoma (3,189 ha, 0.4 %).
What was the weather like?
During the fire the temperature reached 42.9 °C, humidity dropped to 12 % and gusts hit 47 km/h. The fire danger index (FWI) reached 50, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mozambique (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 16. Their median duration was 13 days and their median area 4,319 ha; 25 % went past 10,000 ha. In 2 of 16, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Start date: 24 October 2019 → 17 October 2019.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 24 October 2019 to 29 October 2019. 132 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.