Skip to content
worldfires
AU · Australia · –

Central Highlands (Qld) fire, April 2020 Murweh, Central Highlands (Qld)

Out · last detection 15 Apr 2020, 15:05 UTC

The fire started on 1 April 2020 in Central Highlands (Qld), Australia, and satellites saw it burning for 15 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 5,299 hectares from heat detections, spread across 2 municipalities.

It is the 216th largest in Queensland since 2016 (of 227 with a page). Number 62 in Australia in 2020, of 67.

Burnt area
5,299ha
GWIS perimeter (Copernicus)
Duration
15days
1 Apr 2020 – 15 Apr 2020
Municipalities hit
2
local government areas
Started on
1 Apr
2020
Heat detections
365
in a single hotspot: 45 MW
Danger at start
20
Moderate · FWI index
Average daily power
133MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 1 Apr15 Apr
15 Apr 2020

How it evolved, day by day

1 Apr 2020 · 72 MW · 25 2 Apr 2020 · 106 MW · 21 3 Apr 2020 · 129 MW · 28 4 Apr 2020 · 19 MW · 17 5 Apr 2020 · 258 MW · 43 6 Apr 2020 · 491 MW · 48 7 Apr 2020 · 144 MW · 38 8 Apr 2020 · 12 MW · 8 10 Apr 2020 · 58 MW · 14 11 Apr 2020 · 82 MW · 29 12 Apr 2020 · 414 MW · 66 13 Apr 2020 · 71 MW · 20 14 Apr 2020 · 4 MW · 4 15 Apr 2020 · 8 MW · 4
1 Apr 6 Apr 11 Apr 14 Apr

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

30°high
39km/h · peak gust
20%lowest humidity

It had gone 4 days without rain (1 mm or more) when it started.

This area had burned before

11% of the perimeter overlaps earlier fires recorded since 2016: 569 ha in 2017.

How big is it?

10 km
It burned the equivalent of 3.3% of the area of London (53 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. 3,365 ha
    0.1 %
  2. Central Highlands (Qld) where it started
    1,933 ha
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
1 Apr 30.4 °C 33 % 25 km/h 0.0 mm Moderate 20
2 Apr 28.7 °C 39 % 30 km/h 0.0 mm High 22
3 Apr 28.3 °C 43 % 35 km/h 0.0 mm High 29
4 Apr 28.0 °C 40 % 35 km/h 0.2 mm High 22
5 Apr 27.6 °C 24 % 30 km/h 0.0 mm Moderate 20
6 Apr 27.6 °C 21 % 29 km/h 0.0 mm High 28
7 Apr 27.8 °C 20 % 29 km/h 0.0 mm High 28
8 Apr 26.9 °C 32 % 30 km/h 0.0 mm High 29
9 Apr 27.0 °C 35 % 39 km/h 0.0 mm High 32
10 Apr 28.6 °C 34 % 36 km/h 0.0 mm High 33
11 Apr 30.0 °C 27 % 34 km/h 0.0 mm High 32
12 Apr 28.2 °C 20 % 35 km/h 0.0 mm High 37
13 Apr 27.8 °C 25 % 35 km/h 0.0 mm Very high 38
14 Apr 28.2 °C 29 % 30 km/h 0.0 mm High 31
15 Apr 27.7 °C 23 % 33 km/h 0.0 mm High 38
16 Apr after 28.1 °C 30 % 30 km/h 0.0 mm High 31
17 Apr after 31.0 °C 22 % 22 km/h 0.0 mm High 30
18 Apr after 30.4 °C 24 % 27 km/h 0.0 mm Very high 40
19 Apr after 28.0 °C 23 % 35 km/h 0.0 mm High 34
20 Apr after 29.1 °C 20 % 23 km/h 0.0 mm High 30
21 Apr after 31.1 °C 15 % 19 km/h 0.0 mm Very high 39
22 Apr after 31.5 °C 19 % 18 km/h 0.0 mm High 35
23 Apr after 30.4 °C 22 % 27 km/h 0.0 mm Very high 42
24 Apr after 27.7 °C 37 % 25 km/h 0.0 mm High 28
25 Apr after 28.2 °C 28 % 27 km/h 0.0 mm High 30

Its twins: fires that started in the same weather

It started with an FWI of 20.0, a minimum humidity of 33% and 4 days without rain. Fires in the area that started in weather like this since 2016: 15.

FWI at the start 20.0
Minimum humidity 33 %
Days without rain 4
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Banana fire, February 2025
16,048 ha 17 days FWI 21.1 Min. humidity 32 % 161 km away, in 2025

First rain (1 mm or more) after it ended: 3.9 mm on 10 Mar.

What happened to them

17 days
median duration
9,010 ha
median area
40 %
went past 10,000 ha
4.8 mm
rain at the end (median; 14 of 15 had it)

It stayed below its twins: 5,299 ha against a median of 9,010 ha. It lasted 15 days, against 17 days.

In 1 of 15, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 4.8 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
39km/h · max. gust

It was considered over on 15 Apr, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 14 of 15, with a median of 4.8 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 25 Mar 2020
After · 22 Apr 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 365Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Australia

Frequently asked questions

How long did the Central Highlands (Qld) fire last?
GWIS (Copernicus) dates it between 1 April 2020 and 15 April 2020: 15 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 5,299 hectares (53.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Murweh (3,365 ha, 0.1 %); Central Highlands (Qld) (1,933 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 30.4 °C, humidity dropped to 20 % and gusts hit 39 km/h. The fire danger index (FWI) reached 38, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Australia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 15. Their median duration was 17 days and their median area 9,010 ha; 40 % went past 10,000 ha. In 1 of 15, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 4.8 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 000 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 000.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 365 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.