Skip to content
worldfires
ES · Spain · →

Castrillo de Cabrera fire, 10 April 2017 Castrillo de Cabrera

Out · last detection 10 Apr 2017, 13:22 UTC

The fire started on 10 April 2017 in Castrillo de Cabrera, Spain, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 124 hectares from satellite imagery, spread across a single municipality. According to EGIF (MITECO), it was detected on 10 April 2017 at 08:03 and declared extinguished on 11 April 2017.

It is the 74th largest in León since 2016 (of 86 with a page). Number 125 in Spain in 2017, of 144.

The power measured by the satellite is low (6.1 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
124ha
Copernicus perimeter
Duration
1day
10 Apr 2017 – 10 Apr 2017
Municipalities hit
1
municipalities
Started on
10 Apr
2017
Heat detections
3
in a single hotspot: 6 MW
Danger at start
11
Low · FWI index
Average daily power
13MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 10 Apr10 Apr

How it evolved, day by day

10 Apr 2017 · 13 MW · 3

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

21°high
24km/h · peak gust
18%lowest humidity

It had gone 9 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Castrillo de Cabrera 100 inhabitants · 2.8 km from the centre where it started
    124 ha reached on 10 Apr
    1.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Broadleaved forest96 %
  • Other natural land4.0 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

Official record

According to EGIF (MITECO), this fire started on 10 April 2017 and burned 100 ha (the satellite measured 124 ha).

MITECO, Estadística General de Incendios Forestales (EGIF). This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 Apr 21.4 °C 18 % 24 km/h 0.0 mm Low 11
11 Apr after 22.0 °C 22 % 35 km/h 0.0 mm Moderate 14
12 Apr after 21.6 °C 23 % 35 km/h 0.0 mm Moderate 15
13 Apr after 20.2 °C 27 % 37 km/h 0.2 mm Moderate 15
14 Apr after 17.7 °C 37 % 39 km/h 0.0 mm Moderate 13
15 Apr after 18.7 °C 33 % 24 km/h 0.0 mm Moderate 11
16 Apr after 19.3 °C 19 % 30 km/h 0.0 mm Moderate 15
17 Apr after 21.2 °C 27 % 29 km/h 0.7 mm Moderate 12
18 Apr after 20.8 °C 22 % 37 km/h 0.0 mm Moderate 16
19 Apr after 18.4 °C 13 % 54 km/h 0.3 mm High 25
20 Apr after 19.0 °C 19 % 58 km/h 0.2 mm High 26

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 Apr 2017
After · 17 Apr 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 13 April 2017 the air beside the fire reached 18 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak18 µg/m³
Days over the guideline0 days
PM1029 µg/m³
8910111213
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 3Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain ›

Frequently asked questions

How long did the Castrillo de Cabrera fire last?
Copernicus dates it between 10 April 2017 and 10 April 2017: 1 day between the first and last image with fire. According to EGIF (MITECO), it was detected on 10 April 2017 at 08:03 and declared extinguished on 11 April 2017.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 124 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Castrillo de Cabrera (124 ha, 1.1 %).
Did the fire reach a town?
The fire started in Castrillo de Cabrera and came within 2.8 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 21.4 °C, humidity dropped to 18 % and gusts hit 24 km/h. The fire danger index (FWI) reached 11, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 3 Suomi-NPP VIIRS detections on those dates.
  • Compared with EGIF (MITECO): 100 official ha against 124 ha of perimeter; they agree within 25%.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.