Skip to content
worldfires
ES · Spain ·

Cangas del Narcea fire, 31 December 2021 Cangas del Narcea

Out · last detection 31 Dec 2021, 12:21 UTC

The fire started on 31 December 2021 in Cangas del Narcea, Spain, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 240 hectares from satellite imagery, spread across a single municipality.

It is the 69th largest in Asturias since 2016 (of 225 with a page). Number 53 in Spain in 2021, of 120.

Burnt area
240ha
Copernicus perimeter
Duration
1day
31 Dec 2021 – 31 Dec 2021
Municipalities hit
1
municipalities
Started on
31 Dec
2021
Heat detections
9
in a single hotspot: 59 MW
Danger at start
1
Very low · FWI index
Average daily power
247MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 31 Dec31 Dec

How it evolved, day by day

31 Dec 2021 · 247 MW · 9

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

15°high
48km/h · peak gust
50%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started. Rain came after the fire: 22.8 mm on 4 Jan.

This area had burned before

5% of the perimeter overlaps earlier fires recorded since 2016: 13 ha in 2020.

What happened to each town

  1. Cangas del Narcea 11,282 inhabitants · 10.3 km from the centre where it started
    240 ha reached on 31 Dec
    0.3 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land92 %
  • Broadleaved forest6.2 %
  • Agricultural areas1.2 %

Natura 2000 protected area affected: 100 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
31 Dec 14.9 °C 50 % 48 km/h 0.0 mm Very low 1
1 Jan after 16.0 °C 35 % 53 km/h 0.0 mm Very low 2
2 Jan after 12.5 °C 44 % 46 km/h 0.0 mm Very low 2
3 Jan after 13.6 °C 53 % 73 km/h 0.0 mm Very low 3
4 Jan after 11.8 °C 59 % 80 km/h 22.8 mm Very low 0

Its twins: fires that started in the same weather

It started with an FWI of 0.8, a minimum humidity of 50% and 3 days without rain. Fires in the area that started in weather like this since 2016: 19.

FWI at the start 0.8
Minimum humidity 50 %
Days without rain 3
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Tineo fire, February 2020
684 ha 4 days FWI 0.8 Min. humidity 49 % 34 km away, in 2020

First rain (1 mm or more) after it ended: 5.0 mm on 25 Feb.

What happened to them

3 days
median duration
183 ha
median area
0 %
went past 1,000 ha
5.5 mm
rain at the end (median; 19 of 19 had it)

It burned an area similar to its twins (240 ha against a median of 183 ha) and lasted 1 day, against 3 days.

All of them had rain in the ten days after the end: the first rainy day brought a median of 5.5 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

22.8 mmfirst rain
4 Jan4 days after it ended
48km/h · max. gust

It was considered over on 31 Dec, and on 4 Jan 22.8 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 19 of 19, with a median of 5.5 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 24 Dec 2021
After · 7 Jan 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 31 December 2021 the air beside the fire reached 16 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak16 µg/m³
Days over the guideline0 days
PM1027 µg/m³
29 Dec31 Dec2 Jan
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain

Frequently asked questions

How long did the Cangas del Narcea fire last?
Copernicus dates it between 31 December 2021 and 31 December 2021: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 240 hectares (2.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Cangas del Narcea (240 ha, 0.3 %).
Did the fire reach a town?
The fire started in Cangas del Narcea and came within 10.3 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 14.9 °C, humidity dropped to 50 % and gusts hit 48 km/h. The fire danger index (FWI) reached 1, class Very low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 19. Their median duration was 3 days and their median area 183 ha; 0 % went past 1,000 ha. All of them had rain in the ten days after the end: the first rainy day brought a median of 5.5 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 9 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.