Skip to content
worldfires
ES · Spain · →

Cañamero fire, July 2025 Cañamero

Out · last detection 19 Jul 2025, 12:21 UTC

The fire started on 18 July 2025 in Cañamero, Spain, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 113 hectares from satellite imagery, spread across a single municipality.

It is the 66th largest in Cáceres since 2016 (of 70 with a page). Number 148 in Spain in 2025, of 158.

The power measured by the satellite is low (12.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
113ha
Copernicus perimeter
Duration
2days
18 Jul 2025 – 19 Jul 2025
Municipalities hit
1
municipalities
Started on
18 Jul
2025
Heat detections
14
in a single hotspot: 13 MW
Danger at start
50
Extreme · FWI index
Energy released
83MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 18 Jul19 Jul

How it evolved, day by day

19

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

29°high
44km/h · peak gust
22%lowest humidity

It had gone 17 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Cañamero 1,578 inhabitants · 1.5 km from the town where it started
    114 ha reached on 19 Jul
    0.8 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub58 %
  • Coniferous forest34 %
  • Mixed forest8.6 %

Natura 2000 protected area affected: 48 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Jul 29.3 °C 22 % 44 km/h 0.0 mm Extreme 50
19 Jul 27.9 °C 26 % 41 km/h 0.0 mm Very high 44
20 Jul after 26.0 °C 41 % 49 km/h 0.0 mm Very high 38
21 Jul after 28.8 °C 19 % 27 km/h 0.0 mm High 36
22 Jul after 31.6 °C 19 % 34 km/h 0.0 mm Very high 41
23 Jul after 26.3 °C 29 % 37 km/h 0.0 mm High 38
24 Jul after 30.9 °C 16 % 46 km/h 0.0 mm Extreme 50
25 Jul after 30.1 °C 15 % 48 km/h 0.0 mm Extreme 53
26 Jul after 33.1 °C 14 % 26 km/h 0.0 mm Very high 43
27 Jul after 35.2 °C 14 % 39 km/h 0.0 mm Extreme 50
28 Jul after 35.2 °C 18 % 26 km/h 0.0 mm Very high 43
29 Jul after 32.4 °C 16 % 52 km/h 0.0 mm Extreme 59

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Jul 2025
After · 26 Jul 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 21 July 2025 the air beside the fire reached 19 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak19 µg/m³
Days over the guideline0 days
PM1023 µg/m³
Optical depth0.14
16171819202122
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 14Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain ›

Frequently asked questions

How long did the Cañamero fire last?
Copernicus dates it between 18 July 2025 and 19 July 2025: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 113 hectares (1.1 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Cañamero (114 ha, 0.8 %).
Did the fire reach a town?
The closest fire to a town centre came within 1.5 km of Cañamero. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 29.3 °C, humidity dropped to 22 % and gusts hit 44 km/h. The fire danger index (FWI) reached 50, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.