Skip to content
worldfires
IT · Italy · →

Caccamo fire, August 2021 Caccamo

Out · last detection 11 Aug 2021, 00:19 UTC

The fire started on 8 August 2021 in Caccamo, Italy, and satellites saw it burning for 4 days. Copernicus mapped a burnt perimeter of 191 hectares from satellite imagery, spread across a single municipality.

It is the 111th largest in Palermo since 2016 (of 178 with a page). Number 161 in Italy in 2021, of 291.

The power measured by the satellite is low (11.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
191ha
Copernicus perimeter
Duration
4days
8 Aug 2021 – 11 Aug 2021
Municipalities hit
1
municipalities
Started on
8 Aug
2021
Heat detections
13
in a single hotspot: 12 MW
Danger at start
38
Very high · FWI index
Average daily power
32MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 8 Aug11 Aug
11 Aug 2021

How it evolved, day by day

9 Aug 2021 · 57 MW · 11 11 Aug 2021 · 7 MW · 2
9 Aug 11 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

41°high
45km/h · peak gust
14%lowest humidity

It had gone 20 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Caccamo 7,663 inhabitants · 7.8 km from the centre where it started
    191 ha reached on 9 Aug
    1.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub88 %
  • Broadleaved forest8.8 %
  • Agricultural areas3.1 %

Natura 2000 protected area affected: 0 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
8 Aug 34.1 °C 29 % 42 km/h 0.0 mm Very high 38
9 Aug 36.5 °C 23 % 28 km/h 0.0 mm High 37
10 Aug 39.3 °C 14 % 33 km/h 0.0 mm Very high 46
11 Aug 41.3 °C 17 % 45 km/h 0.0 mm Very high 47
12 Aug after 36.9 °C 29 % 34 km/h 0.0 mm Very high 39
13 Aug after 36.0 °C 28 % 27 km/h 0.0 mm High 36
14 Aug after 35.0 °C 32 % 22 km/h 0.0 mm High 33
15 Aug after 34.3 °C 32 % 23 km/h 0.0 mm High 32
16 Aug after 34.7 °C 32 % 28 km/h 0.0 mm High 34
17 Aug after 34.8 °C 36 % 52 km/h 0.0 mm Very high 40
18 Aug after 31.5 °C 47 % 37 km/h 0.0 mm High 30
19 Aug after 31.0 °C 46 % 28 km/h 0.0 mm High 26
20 Aug after 31.9 °C 47 % 28 km/h 0.2 mm High 27
21 Aug after 30.6 °C 45 % 36 km/h 0.0 mm High 27

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 1 Aug 2021
After · 18 Aug 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 11 August 2021 the air beside the fire reached 36 µg/m³ of PM2.5. That day averaged 27: 1.8 times the WHO daily guideline (15).

PM2.5 peak36 µg/m³
Days over the guideline6 days
PM1084 µg/m³
67891011121314
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 13Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Caccamo fire last?
Copernicus dates it between 8 August 2021 and 11 August 2021: 4 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 191 hectares (1.9 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Caccamo (191 ha, 1.0 %).
Did the fire reach a town?
The fire started in Caccamo and came within 7.8 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 41.3 °C, humidity dropped to 14 % and gusts hit 45 km/h. The fire danger index (FWI) reached 47, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 13 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.