Skip to content
worldfires
IT · Italy · →

Butera fire, 13 July 2025 Butera

Out · last detection 13 Jul 2025, 12:32 UTC

The fire started on 13 July 2025 in Butera, Italy, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 104 hectares from satellite imagery, spread across a single municipality.

It is the 143th largest in Caltanissetta since 2016 (of 149 with a page). Number 203 in Italy in 2025, of 216.

The power measured by the satellite is low (4.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
104ha
Copernicus perimeter
Duration
1day
13 Jul 2025 – 13 Jul 2025
Municipalities hit
1
municipalities
Started on
13 Jul
2025
Heat detections
2
in a single hotspot: 5 MW
Danger at start
28
High · FWI index
Average daily power
10MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 13 Jul13 Jul

How it evolved, day by day

13 Jul 2025 · 10 MW · 2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

30°high
34km/h · peak gust
46%lowest humidity

It had gone 8 days without rain (1 mm or more) when it started.

This area had burned before

99% of the perimeter overlaps earlier fires recorded since 2016: 30 ha in 2017, 7 ha in 2020, 69 ha in 2021, 36 ha in 2022, 53 ha in 2023. Part of it burned more than once, so the yearly figures add up to more than the 103 ha that had burned before.

What happened to each town

  1. Butera 4,164 inhabitants · 0.6 km from the centre where it started
    104 ha reached on 13 Jul
    0.4 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land55 %
  • Agricultural areas45 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
13 Jul 29.8 °C 46 % 34 km/h 0.0 mm High 28
14 Jul after 33.9 °C 36 % 35 km/h 0.0 mm High 30
15 Jul after 34.3 °C 29 % 41 km/h 0.0 mm Very high 39
16 Jul after 34.6 °C 31 % 21 km/h 0.0 mm High 30
17 Jul after 32.8 °C 40 % 42 km/h 0.0 mm High 36
18 Jul after 31.0 °C 55 % 26 km/h 0.0 mm High 23
19 Jul after 31.4 °C 60 % 36 km/h 0.0 mm High 24
20 Jul after 32.2 °C 47 % 34 km/h 0.0 mm High 25
21 Jul after 35.1 °C 43 % 30 km/h 0.0 mm High 28
22 Jul after 39.1 °C 28 % 35 km/h 0.0 mm Very high 40
23 Jul after 36.7 °C 30 % 34 km/h 0.0 mm Very high 39

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 6 Jul 2025
After · 20 Jul 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 12 July 2025 the air beside the fire reached 8 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak8 µg/m³
Days over the guideline0 days
PM1013 µg/m³
Optical depth0.27
111213141516
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Butera fire last?
Copernicus dates it between 13 July 2025 and 13 July 2025: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 104 hectares (1.0 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Butera (104 ha, 0.4 %).
Did the fire reach a town?
The fire started in Butera and came within 0.6 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 29.8 °C, humidity dropped to 46 % and gusts hit 34 km/h. The fire danger index (FWI) reached 28, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 2 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.