Skip to content
worldfires
DZ · Algeria ·

Bordj Tahar fire, October 2023 برج الطهر · Bordj Tahar, Chekfa

Out · last detection 24 Oct 2023, 02:25 UTC

The fire started on 24 October 2023 in Bordj Tahar, Algeria, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 117 hectares from satellite imagery, spread across 2 municipalities.

It is the 88th largest in Jijel since 2016 (of 110 with a page). Number 75 in Algeria in 2023, of 86.

The power measured by the satellite is low (2.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
117ha
Copernicus perimeter
Duration
1day
24 Oct 2023 – 24 Oct 2023
Municipalities hit
2
communes
Started on
24 Oct
2023
Heat detections
3
in a single hotspot: 3 MW
Danger at start
19
Moderate · FWI index
Average daily power
6MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 24 Oct24 Oct

How it evolved, day by day

24 Oct 2023 · 6 MW · 3

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

22°high
32km/h · peak gust
33%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started. Rain came after the fire: 4.9 mm on 25 Oct.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Bordj Tahar برج الطهر 3,889 inhabitants · 0.7 km from the centre where it started
    116 ha reached on 24 Oct
    2.3 %
  2. Chekfa الشقفة 26,553 inhabitants · 6.8 km from the centre
    1 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Mixed forest99 %
  • Broadleaved forest0.8 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
24 Oct 21.9 °C 33 % 32 km/h 3.8 mm Moderate 19
25 Oct after 19.7 °C 46 % 40 km/h 4.9 mm Low 6

Its twins: fires that started in the same weather

It started with an FWI of 19.2, a minimum humidity of 33% and 3 days without rain. Fires in the area that started in weather like this since 2016: 34.

FWI at the start 19.2
Minimum humidity 33 %
Days without rain 3
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Bejaia fire, November 2016
843 ha 2 days FWI 23.3 Min. humidity 33 % 95 km away, in 2016

First rain (1 mm or more) after it ended: 18.7 mm on 7 Nov.

What happened to them

2 days
median duration
240 ha
median area
6 %
went past 1,000 ha
2.0 mm
rain at the end (median; 31 of 34 had it)

It stayed below its twins: 117 ha against a median of 240 ha. It lasted 1 day, against 2 days.

In 3 of 34, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

4.9 mmfirst rain
25 Octthe day after it ended
32km/h · max. gust

It was considered over on 24 Oct, and on 25 Oct 4.9 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 31 of 34, with a median of 2.0 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 17 Oct 2023
After · 31 Oct 2023

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 24 October 2023 the air beside the fire reached 30 µg/m³ of PM2.5. That day averaged 21: 1.4 times the WHO daily guideline (15).

PM2.5 peak30 µg/m³
Days over the guideline2 days
PM1099 µg/m³
Optical depth0.68
22 Oct24 Oct26 Oct
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 3Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria

Frequently asked questions

How long did the Bordj Tahar fire last?
Copernicus dates it between 24 October 2023 and 24 October 2023: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 117 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Bordj Tahar (116 ha, 2.3 %); Chekfa (1 ha, 0.0 %).
Did the fire reach a town?
The fire started in Bordj Tahar and came within 0.7 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 21.9 °C, humidity dropped to 33 % and gusts hit 32 km/h. The fire danger index (FWI) reached 19, class Moderate.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 34. Their median duration was 2 days and their median area 240 ha; 6 % went past 1,000 ha. In 3 of 34, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 3 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.