Skip to content
worldfires
DZ · Algeria · →

Boghni fire, August 2019 بوغني · Boghni, Bounouh, Taghzout

Out · last detection 9 Aug 2019, 12:24 UTC

The fire started on 7 August 2019 in Boghni, Algeria, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 492 hectares from satellite imagery, spread across 3 municipalities.

It is the 13th largest in Tizi Ouzou since 2016 (of 46 with a page). Number 24 in Algeria in 2019, of 78.

The power measured by the satellite is low (7.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
492ha
Copernicus perimeter
Duration
3days
7 Aug 2019 – 9 Aug 2019
Municipalities hit
3
communes
Started on
7 Aug
2019
Heat detections
14
in a single hotspot: 7 MW
Danger at start
42
Very high · FWI index
Average daily power
17MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 7 Aug9 Aug
9 Aug 2019

How it evolved, day by day

7 Aug 2019 · 7 MW · 1 8 Aug 2019 · 32 MW · 10 9 Aug 2019 · 11 MW · 3
7 Aug 8 Aug 9 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
37km/h · peak gust
15%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started. Rain came after the fire: 2.6 mm on 13 Aug.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Boghni بوغني 31,263 inhabitants · 6.9 km from the centre where it started
    337 ha reached on 7 Aug
    6.6 %
  2. Bounouh بونوح 9,731 inhabitants · 3.2 km from the centre
    144 ha reached on 8 Aug
    5.3 %
  3. Taghzout تاغزوت 13,203 inhabitants · 4.8 km from the centre
    12 ha
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Mixed forest51 %
  • Other natural land49 %

Protected area affected (EFFIS layer): 77 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
8 Aug 34.0 °C 23 % 37 km/h 0.0 mm Very high 42
9 Aug 35.9 °C 15 % 37 km/h 0.0 mm Very high 45
10 Aug after 36.7 °C 16 % 40 km/h 0.0 mm Very high 45
11 Aug after 35.9 °C 19 % 42 km/h 0.8 mm Very high 39
12 Aug after 31.3 °C 30 % 42 km/h 0.7 mm High 31
13 Aug after 28.5 °C 48 % 41 km/h 2.6 mm Low 9

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 31 Jul 2019
After · 16 Aug 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 5 August 2019 the air beside the fire reached 35 µg/m³ of PM2.5. That day averaged 28: 1.8 times the WHO daily guideline (15).

PM2.5 peak35 µg/m³
Days over the guideline6 days
PM1066 µg/m³
56789101112
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 14Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Boghni fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 7 August 2019 to 9 August 2019 (3 days). The perimeter dates it from 8 August 2019 to 9 August 2019.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 492 hectares (4.9 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Boghni (337 ha, 6.6 %); Bounouh (144 ha, 5.3 %); Taghzout (12 ha, 0.2 %).
Did the fire reach a town?
The fire came within 3.2 km of the centre of Bounouh, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 35.9 °C, humidity dropped to 15 % and gusts hit 37 km/h. The fire danger index (FWI) reached 45, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 8 August 2019 to 9 August 2019. 14 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.