Skip to content
worldfires
TR · Türkiye · →

Bitlis merkez fire, 26 July 2018 Bitlis · Bitlis merkez

Out · last detection 28 Jul 2018, 10:11 UTC

The fire started on 26 July 2018 in Bitlis merkez, Türkiye, and satellites saw it burning for 4 days. Copernicus mapped a burnt perimeter of 138 hectares from satellite imagery, spread across a single municipality.

It is the 16th largest in Bitlis since 2016 (of 19 with a page). Number 73 in Türkiye in 2018, of 104.

The power measured by the satellite is low (9.1 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
138ha
Copernicus perimeter
Duration
4days
26 Jul 2018 – 29 Jul 2018
Municipalities hit
1
districts
Started on
26 Jul
2018
Heat detections
10
in a single hotspot: 9 MW
Danger at start
47
Very high · FWI index
Average daily power
18MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 26 Jul29 Jul
28 Jul 2018

How it evolved, day by day

26 Jul 2018 · 6 MW · 3 27 Jul 2018 · 22 MW · 4 28 Jul 2018 · 25 MW · 3
26 Jul 27 Jul 28 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
47km/h · peak gust
11%lowest humidity

It had gone 41 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Bitlis merkez Bitlis 52,024 inhabitants · 12.9 km from the centre where it started
    138 ha reached on 26 Jul
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Broadleaved forest70 %
  • Scrub and transitional woodland30 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
27 Jul 33.4 °C 11 % 37 km/h 0.0 mm Very high 47
28 Jul 33.5 °C 11 % 45 km/h 0.0 mm Very high 49
29 Jul 34.2 °C 16 % 47 km/h 0.0 mm Extreme 51
30 Jul after 33.8 °C 18 % 45 km/h 0.0 mm Extreme 51
31 Jul after 33.4 °C 23 % 41 km/h 0.0 mm Very high 46
1 Aug after 32.5 °C 25 % 34 km/h 0.0 mm Very high 40
2 Aug after 33.2 °C 20 % 25 km/h 0.0 mm Very high 39
3 Aug after 32.8 °C 20 % 47 km/h 0.0 mm Very high 47
4 Aug after 29.8 °C 28 % 48 km/h 0.2 mm Very high 42
5 Aug after 31.8 °C 23 % 43 km/h 0.0 mm Very high 41
6 Aug after 33.6 °C 15 % 37 km/h 0.0 mm Very high 44
7 Aug after 33.3 °C 13 % 41 km/h 0.0 mm Very high 47
8 Aug after 33.5 °C 15 % 42 km/h 0.0 mm Very high 47

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 19 Jul 2018
After · 5 Aug 2018

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 1 August 2018 the air beside the fire reached 22 µg/m³ of PM2.5. That day averaged 17: 1.1 times the WHO daily guideline (15).

PM2.5 peak22 µg/m³
Days over the guideline2 days
PM1041 µg/m³
24252627282930311
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 10Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Bitlis merkez fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 26 July 2018 to 29 July 2018 (4 days). The perimeter dates it from 27 July 2018 to 29 July 2018.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 138 hectares (1.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Bitlis merkez (138 ha, 0.1 %).
Did the fire reach a town?
The fire started in Bitlis merkez and came within 12.9 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 34.2 °C, humidity dropped to 11 % and gusts hit 47 km/h. The fire danger index (FWI) reached 51, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 27 July 2018 to 29 July 2018. 10 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.