Skip to content
worldfires
UA · Ukraine · →

Bilozerka fire, 14 June 2026 Білозерський район · Bilozerka

Out · last detection 17 Jun 2026, 10:05 UTC

The fire started on 14 June 2026 in Bilozerka, Ukraine, and satellites saw it burning for 9 days. Copernicus mapped a burnt perimeter of 227 hectares from satellite imagery, spread across a single municipality.

It is the 526th largest in Kherson Oblast since 2016 (of 1103 with a page). Number 397 in Ukraine in 2026, of 984.

Compare with…
Burnt area
227ha
Copernicus perimeter
Duration
≈ 9days
14 Jun 2026 – 22 Jun 2026
Municipalities hit
1
districts
Started on
14 Jun
2026
Heat detections
8
in a single hotspot: 41 MW
Danger at start
12
Moderate · FWI index
Average daily power
29MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 14 Jun22 Jun
17 Jun 2026

How it evolved, day by day

14 Jun 2026 · 9 MW · 3 16 Jun 2026 · 21 MW · 2 17 Jun 2026 · 57 MW · 3
14 Jun 16 Jun 17 Jun

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

23°high
35km/h · peak gust
49%lowest humidity

It had gone one day without rain (1 mm or more) when it started. Rain came after the fire: 1.3 mm on 16 Jun.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Bilozerka Білозерський район 64,790 inhabitants · 7.7 km from the centre where it started
    227 ha reached on 14 Jun
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas96 %
  • Other natural land4.4 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

People and buildings inside the perimeter

GHSL 2025
Built-up area0.38 ha
Residents< 20

Inside the perimeter there were about 0.38 hectares of built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
14 Jun 23.4 °C 49 % 35 km/h 0.0 mm Moderate 12
15 Jun 21.9 °C 64 % 33 km/h 0.7 mm Low 9
16 Jun 23.7 °C 54 % 37 km/h 1.3 mm Low 7

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Jun 2026
After · 29 Jun 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 12 June 2026 the air beside the fire reached 7 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak7 µg/m³
Days over the guideline0 days
PM1010 µg/m³
Optical depth0.37
121314151617
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 8Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Bilozerka fire last?
The official perimeter only gives the start date (14 June 2026). The end comes from the heat detections inside the perimeter: it burned until 22 June 2026 (9 days from 14 June 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 227 hectares (2.3 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Bilozerka (227 ha, 0.2 %).
Did the fire reach a town?
The fire started in Bilozerka and came within 7.7 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 23.4 °C, humidity dropped to 49 % and gusts hit 35 km/h. The fire danger index (FWI) reached 12, class Moderate.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 8 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.