Skip to content
worldfires
IN · India · –

Bhopalpattnam fire, March 2017 Bhopalpattnam

Out · last detection 13 Apr 2017, 07:14 UTC

The fire started on 25 March 2017 in Bhopalpattnam, India, and satellites saw it burning for 20 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 7,578 hectares from heat detections, spread across a single municipality.

It is the 10th largest in Chhattīsgarh since 2016 (of 26 with a page). Number 6 in India in 2017, of 27.

Burnt area
7,578ha
GWIS perimeter (Copernicus)
Duration
20days
25 Mar 2017 – 13 Apr 2017
Municipalities hit
1
subdistricts
Started on
25 Mar
2017
Heat detections
318
in a single hotspot: 35 MW
Danger at start
42
Very high · FWI index
Average daily power
106MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 25 Mar13 Apr
13 Apr 2017

How it evolved, day by day

25 Mar 2017 · 34 MW · 5 26 Mar 2017 · 11 MW · 1 27 Mar 2017 · 6 MW · 2 28 Mar 2017 · 14 MW · 5 29 Mar 2017 · 40 MW · 6 30 Mar 2017 · 7 MW · 1 31 Mar 2017 · 54 MW · 8 1 Apr 2017 · 68 MW · 16 2 Apr 2017 · 126 MW · 18 3 Apr 2017 · 28 MW · 5 4 Apr 2017 · 149 MW · 21 5 Apr 2017 · 106 MW · 26 6 Apr 2017 · 398 MW · 59 7 Apr 2017 · 234 MW · 50 8 Apr 2017 · 136 MW · 25 9 Apr 2017 · 211 MW · 32 10 Apr 2017 · 243 MW · 30 11 Apr 2017 · 133 MW · 6 13 Apr 2017 · 5 MW · 2
25 Mar 29 Mar 2 Apr 6 Apr 10 Apr

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

43°high
41km/h · peak gust
4%lowest humidity

It had gone 7 days without rain (1 mm or more) when it started.

This area had burned before

50% of the perimeter overlaps earlier fires recorded since 2016: 3,820 ha in 2016.

How big is it?

10 km
It burned the equivalent of 4.8% of the area of London (76 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Bhopalpattnam where it started
    7,630 ha reached on 25 Mar
    3.4 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
25 Mar 40.0 °C 23 % 26 km/h 0.0 mm Very high 42
26 Mar 40.1 °C 25 % 27 km/h 0.0 mm High 37
27 Mar 39.0 °C 25 % 27 km/h 0.0 mm Very high 39
28 Mar 39.7 °C 26 % 27 km/h 0.0 mm Very high 40
29 Mar 40.1 °C 25 % 29 km/h 0.0 mm Very high 40
30 Mar 40.7 °C 24 % 30 km/h 0.0 mm Very high 43
31 Mar 41.5 °C 20 % 27 km/h 0.0 mm Very high 40
1 Apr 40.4 °C 26 % 28 km/h 0.0 mm Very high 43
2 Apr 40.6 °C 25 % 37 km/h 0.7 mm Very high 46
3 Apr 39.9 °C 27 % 41 km/h 0.0 mm Very high 45
4 Apr 39.8 °C 31 % 34 km/h 0.0 mm Very high 41
5 Apr 40.0 °C 36 % 40 km/h 0.2 mm Very high 44
6 Apr 41.2 °C 21 % 33 km/h 0.0 mm High 38
7 Apr 40.9 °C 28 % 36 km/h 0.0 mm Very high 42
8 Apr 42.4 °C 23 % 26 km/h 0.0 mm Very high 41
9 Apr 43.0 °C 14 % 24 km/h 0.0 mm Very high 45
10 Apr 42.9 °C 10 % 32 km/h 0.0 mm Extreme 56
11 Apr 42.4 °C 7 % 34 km/h 0.0 mm Extreme 68
12 Apr 42.9 °C 4 % 30 km/h 0.0 mm Extreme 65
13 Apr 42.9 °C 7 % 25 km/h 0.0 mm Extreme 56
14 Apr after 41.9 °C 14 % 28 km/h 0.0 mm Extreme 55
15 Apr after 41.7 °C 15 % 35 km/h 0.0 mm Extreme 56
16 Apr after 43.7 °C 11 % 29 km/h 0.0 mm Extreme 51
17 Apr after 44.2 °C 11 % 34 km/h 0.0 mm Very high 50
18 Apr after 43.2 °C 16 % 34 km/h 0.0 mm Very high 49
19 Apr after 42.1 °C 23 % 37 km/h 0.0 mm Very high 48
20 Apr after 42.8 °C 20 % 38 km/h 0.0 mm Very high 45
21 Apr after 41.8 °C 19 % 34 km/h 0.0 mm Very high 43
22 Apr after 43.5 °C 13 % 26 km/h 0.0 mm Extreme 51
23 Apr after 43.2 °C 13 % 31 km/h 0.0 mm Extreme 57

Its twins: fires that started in the same weather

It started with an FWI of 41.7, a minimum humidity of 23% and 7 days without rain. Fires in the area that started in weather like this since 2016: 12.

FWI at the start 41.7
Minimum humidity 23 %
Days without rain 7
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Bhamragad fire, April 2016
7,316 ha 15 days FWI 40.2 Min. humidity 20 % 46 km away, in 2016

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

Fires in the area that started in similar weather: 12. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
41km/h · max. gust

It was considered over on 13 Apr, and not even 1 mm fell in the following ten days: it went out without rain.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 18 Mar 2017
After · 20 Apr 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 318Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in India

Frequently asked questions

How long did the Bhopalpattnam fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 25 March 2017 to 13 April 2017 (20 days). The perimeter dates it from 29 March 2017 to 10 April 2017.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 7,578 hectares (75.8 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Bhopalpattnam (7,630 ha, 3.4 %).
What was the weather like?
During the fire the temperature reached 43.0 °C, humidity dropped to 4 % and gusts hit 41 km/h. The fire danger index (FWI) reached 68, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of India (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 10 April 2017 → 13 April 2017.
  2. Start date: 29 March 2017 → 25 March 2017.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 29 March 2017 to 10 April 2017. 318 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.