Skip to content
worldfires
DZ · Algeria · →

Beni Bouattab fire, August 2020 بني بوعتاب · Beni Bouattab, Bathia

Out · last detection 28 Aug 2020, 13:46 UTC

The fire started on 28 August 2020 in Beni Bouattab, Algeria, and satellites saw it burning for 4 days. Copernicus mapped a burnt perimeter of 116 hectares from satellite imagery, spread across 2 municipalities.

It is the 31th largest in Aïn Defla since 2016 (of 36 with a page). Number 211 in Algeria in 2020, of 236.

The power measured by the satellite is low (12.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
116ha
Copernicus perimeter
Duration
4days
28 Aug 2020 – 31 Aug 2020
Municipalities hit
2
communes
Started on
28 Aug
2020
Heat detections
4
in a single hotspot: 12 MW
Danger at start
48
Very high · FWI index
Average daily power
46MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 28 Aug31 Aug

How it evolved, day by day

28 Aug 2020 · 46 MW · 4

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
43km/h · peak gust
19%lowest humidity

It had gone 12 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Beni Bouattab بني بوعتاب 2,069 inhabitants · 7.9 km from the centre where it started
    78 ha reached on 28 Aug
    0.6 %
  2. Bathia بطحية 6,238 inhabitants · 13.2 km from the centre
    39 ha
    0.4 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land59 %
  • Mixed forest41 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
28 Aug 34.4 °C 19 % 43 km/h 0.0 mm Very high 48
29 Aug 31.8 °C 22 % 50 km/h 0.0 mm Extreme 52
30 Aug 26.8 °C 30 % 40 km/h 0.0 mm Very high 40
31 Aug 27.0 °C 25 % 35 km/h 0.0 mm High 38
1 Sept after 30.3 °C 24 % 39 km/h 0.0 mm Very high 40
2 Sept after 26.2 °C 34 % 41 km/h 0.3 mm High 35
3 Sept after 27.8 °C 32 % 44 km/h 0.0 mm Very high 38
4 Sept after 31.4 °C 23 % 41 km/h 0.0 mm Very high 39
5 Sept after 28.1 °C 40 % 36 km/h 0.0 mm High 32
6 Sept after 27.9 °C 37 % 33 km/h 0.0 mm High 32
7 Sept after 28.3 °C 30 % 35 km/h 0.0 mm High 32

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 21 Aug 2020
After · 7 Sept 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 30 August 2020 the air beside the fire reached 11 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak11 µg/m³
Days over the guideline0 days
PM1019 µg/m³
262728293031
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 4Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Beni Bouattab fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 28 August 2020 to 31 August 2020 (4 days). The perimeter dates it from 28 August 2020 to 28 August 2020.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 116 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Beni Bouattab (78 ha, 0.6 %); Bathia (39 ha, 0.4 %).
Did the fire reach a town?
The fire started in Beni Bouattab and came within 7.9 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 34.4 °C, humidity dropped to 19 % and gusts hit 43 km/h. The fire danger index (FWI) reached 48, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 28 August 2020 to 28 August 2020. 4 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.