Skip to content
worldfires
BJ · Benin · –

Bassila fire, 14 February 2017 Bassila

Out · last detection 20 Feb 2017, 13:32 UTC

The fire started on 14 February 2017 in Bassila, Benin, and satellites saw it burning for 7 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,843 hectares from heat detections, spread across a single municipality.

It is the 3th largest in Donga since 2016 (of 46 with a page). Number 16 in Benin in 2017, of 153.

The power measured by the satellite is low (23.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
3,843ha
GWIS perimeter (Copernicus)
Duration
7days
14 Feb 2017 – 20 Feb 2017
Municipalities hit
1
communes
Started on
14 Feb
2017
Heat detections
123
in a single hotspot: 24 MW
Danger at start
47
Very high · FWI index
Average daily power
62MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 14 Feb20 Feb
20 Feb 2017

How it evolved, day by day

14 Feb 2017 · 1 MW · 1 15 Feb 2017 · 80 MW · 7 16 Feb 2017 · 53 MW · 11 17 Feb 2017 · 44 MW · 14 18 Feb 2017 · 222 MW · 69 19 Feb 2017 · 30 MW · 19 20 Feb 2017 · 5 MW · 2
14 Feb 16 Feb 18 Feb 20 Feb

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
35km/h · peak gust
8%lowest humidity

It had gone 12 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 2.4% of the area of London (38 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Bassila where it started
    3,891 ha reached on 14 Feb
    0.7 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Very dry air: 49 % of the area in Benin

Day High Min. humidity Peak gust Rain Danger (FWI)
14 Feb 35.8 °C 8 % 34 km/h 0.0 mm Very high 47
15 Feb 34.8 °C 10 % 31 km/h 0.0 mm Very high 48
16 Feb 34.7 °C 8 % 31 km/h 0.0 mm Very high 49
17 Feb 33.6 °C 9 % 32 km/h 0.0 mm Extreme 50
18 Feb 33.7 °C 10 % 35 km/h 0.0 mm Extreme 51
19 Feb 33.6 °C 12 % 27 km/h 0.0 mm Very high 50
20 Feb 34.8 °C 16 % 24 km/h 0.0 mm Very high 43
21 Feb after 34.6 °C 31 % 24 km/h 0.0 mm High 37
22 Feb after 35.6 °C 24 % 27 km/h 0.0 mm High 37
23 Feb after 35.2 °C 29 % 24 km/h 0.0 mm High 36
24 Feb after 36.8 °C 29 % 27 km/h 0.0 mm High 35
25 Feb after 37.6 °C 26 % 24 km/h 0.0 mm High 36
26 Feb after 35.8 °C 28 % 23 km/h 0.0 mm Very high 39
27 Feb after 36.4 °C 25 % 23 km/h 0.0 mm Very high 38
28 Feb after 37.3 °C 26 % 24 km/h 0.0 mm Very high 38
1 Mar after 37.0 °C 28 % 32 km/h 0.0 mm Very high 43
2 Mar after 36.5 °C 29 % 26 km/h 0.0 mm Very high 38

Its twins: fires that started in the same weather

It started with an FWI of 47.3, a minimum humidity of 8% and 12 days without rain. Fires in the area that started in weather like this since 2016: 18.

FWI at the start 47.3
Minimum humidity 8 %
Days without rain 12
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Nkwanta South fire, January 2020
6,542 ha 23 days FWI 48.6 Min. humidity 10 % 198 km away, in 2020

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

10 days
median duration
2,013 ha
median area
100 %
went past 1,000 ha
3.9 mm
rain at the end (median; 2 of 18 had it)

It was 1.9 times larger than the median of its twins and lasted 7 days, against 10 days.

Only 1 of its 18 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 16 of 18, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.9 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
35km/h · max. gust

It was considered over on 20 Feb, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 2 of 18, with a median of 3.9 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Feb 2017
After · 27 Feb 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 123Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Benin

Frequently asked questions

How long did the Bassila fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 14 February 2017 to 20 February 2017 (7 days). The perimeter dates it from 15 February 2017 to 20 February 2017.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,843 hectares (38.4 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Bassila (3,891 ha, 0.7 %).
What was the weather like?
During the fire the temperature reached 35.8 °C, humidity dropped to 8 % and gusts hit 35 km/h. The fire danger index (FWI) reached 51, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Benin (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 18. Their median duration was 10 days and their median area 2,013 ha; 100 % went past 1,000 ha. Only 1 of its 18 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 16 of 18, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.9 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery; 2 polygons grouped in this page.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 15 February 2017 to 20 February 2017. 123 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.