Skip to content
worldfires
SN · Senegal · →

Bandafassi fire, 27 January 2025 Bandafassi

Out · last detection 30 Jan 2025, 13:41 UTC

The fire started on 27 January 2025 in Bandafassi, Senegal, and satellites saw it burning for 4 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,429 hectares from heat detections, spread across a single municipality.

It is the 51th largest in Kédougou since 2016 (of 116 with a page). Number 27 in Senegal in 2025, of 112.

Burnt area
3,429ha
GWIS perimeter (Copernicus)
Duration
4days
27 Jan 2025 – 30 Jan 2025
Municipalities hit
1
districts
Started on
27 Jan
2025
Heat detections
95
in a single hotspot: 65 MW
Danger at start
57
Extreme · FWI index
Energy released
996MW
sum of detected power

Where it burned

30 Jan 2025
HOTSPOTS BY DAY 27 Jan30 Jan

How it evolved, day by day

27282930

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

40°high
43km/h · peak gust
9%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

99% of the perimeter overlaps earlier fires recorded since 2016: 2,179 ha in 2016, 222 ha in 2017, 144 ha in 2018, 1,683 ha in 2019, 2,102 ha in 2020, 1,786 ha in 2021, 2,202 ha in 2022, 1,648 ha in 2023, 1,264 ha in 2024. Part of it burned more than once, so the yearly figures add up to more than the 3,385 ha that had burned before.

What happened to each town

  1. Bandafassi where it started
    3,453 ha reached on 27 Jan
    0.6 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
27 Jan 39.5 °C 14 % 38 km/h 0.0 mm Extreme 57
28 Jan 39.3 °C 11 % 42 km/h 0.0 mm Extreme 60
29 Jan 38.2 °C 9 % 43 km/h 0.0 mm Extreme 63
30 Jan 38.4 °C 9 % 39 km/h 0.0 mm Extreme 57
31 Jan after 37.0 °C 12 % 44 km/h 0.0 mm Extreme 63
1 Feb after 35.1 °C 14 % 40 km/h 0.0 mm Extreme 61
2 Feb after 31.9 °C 15 % 45 km/h 0.0 mm Extreme 61
3 Feb after 32.9 °C 15 % 40 km/h 0.0 mm Extreme 58
4 Feb after 34.7 °C 14 % 31 km/h 0.0 mm Extreme 54
5 Feb after 34.8 °C 15 % 36 km/h 0.0 mm Extreme 55
6 Feb after 35.1 °C 13 % 38 km/h 0.0 mm Extreme 57
7 Feb after 35.3 °C 13 % 38 km/h 0.0 mm Extreme 57
8 Feb after 36.9 °C 16 % 38 km/h 0.0 mm Extreme 57
9 Feb after 38.9 °C 16 % 34 km/h 0.0 mm Extreme 54

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 20 Jan 2025
After · 6 Feb 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 25 January 2025 the air beside the fire reached 83 µg/m³ of PM2.5. That day averaged 54: 3.6 times the WHO daily guideline (15).

PM2.5 peak83 µg/m³
Days over the guideline9 days
PM10264 µg/m³
Optical depth0.61
2526272829303112
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 95Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Senegal ›

Frequently asked questions

How long did the Bandafassi fire last?
GWIS (Copernicus) dates it between 27 January 2025 and 30 January 2025: 4 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,429 hectares (34.3 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Bandafassi (3,453 ha, 0.6 %).
What was the weather like?
During the fire the temperature reached 39.5 °C, humidity dropped to 9 % and gusts hit 43 km/h. The fire danger index (FWI) reached 63, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Senegal (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 18

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 18.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.