Skip to content
worldfires
SD · Sudan · →

Babanusa fire, November 2025 Babanusa

Out · last detection 16 Nov 2025, 11:24 UTC

The fire started on 8 November 2025 in Babanusa, Sudan, and satellites saw it burning for 9 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 5,862 hectares from heat detections, spread across a single municipality.

It is the 15th largest in West Kordofan since 2016 (of 183 with a page). Number 57 in Sudan in 2025, of 390.

The power measured by the satellite is low (28.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
5,862ha
GWIS perimeter (Copernicus)
Duration
9days
8 Nov 2025 – 16 Nov 2025
Municipalities hit
1
localities
Started on
8 Nov
2025
Heat detections
86
in a single hotspot: 28 MW
Danger at start
49
Very high · FWI index
Average daily power
77MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 8 Nov16 Nov
16 Nov 2025

How it evolved, day by day

8 Nov 2025 · 1 MW · 1 9 Nov 2025 · 403 MW · 40 10 Nov 2025 · 2 MW · 2 12 Nov 2025 · 2 MW · 1 13 Nov 2025 · 3 MW · 1 14 Nov 2025 · 82 MW · 14 15 Nov 2025 · 32 MW · 11 16 Nov 2025 · 92 MW · 16
8 Nov 9 Nov 10 Nov 13 Nov 15 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
47km/h · peak gust
11%lowest humidity

It had gone 34 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 3.7% of the area of London (59 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Babanusa where it started
    5,898 ha reached on 8 Nov
    2.5 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area91 ha
Residents≈ 12,000

Inside the perimeter there were about 91 hectares of built-up land and about 12,000 residents (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
9 Nov 35.9 °C 12 % 35 km/h 0.0 mm Very high 49
10 Nov 35.6 °C 16 % 30 km/h 0.0 mm Very high 47
11 Nov 37.1 °C 16 % 29 km/h 0.0 mm Very high 45
12 Nov 36.5 °C 17 % 34 km/h 0.0 mm Very high 48
13 Nov 36.4 °C 14 % 35 km/h 0.0 mm Extreme 52
14 Nov 34.5 °C 13 % 47 km/h 0.0 mm Extreme 59
15 Nov 31.3 °C 11 % 44 km/h 0.0 mm Extreme 58
16 Nov 31.9 °C 13 % 38 km/h 0.0 mm Extreme 54
17 Nov after 33.4 °C 14 % 36 km/h 0.0 mm Extreme 52
18 Nov after 35.1 °C 19 % 39 km/h 0.0 mm Extreme 52
19 Nov after 35.7 °C 17 % 41 km/h 0.0 mm Extreme 54
20 Nov after 35.8 °C 13 % 35 km/h 0.0 mm Extreme 51
21 Nov after 35.5 °C 12 % 29 km/h 0.0 mm Very high 49
22 Nov after 35.9 °C 15 % 31 km/h 0.0 mm Extreme 50
23 Nov after 37.1 °C 16 % 27 km/h 0.0 mm Very high 45
24 Nov after 37.0 °C 15 % 30 km/h 0.0 mm Very high 48
25 Nov after 36.1 °C 15 % 30 km/h 0.0 mm Extreme 54
26 Nov after 35.7 °C 13 % 40 km/h 0.0 mm Extreme 57

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 1 Nov 2025
After · 23 Nov 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 14 November 2025 the air beside the fire reached 33 µg/m³ of PM2.5. That day averaged 23: 1.5 times the WHO daily guideline (15).

PM2.5 peak33 µg/m³
Days over the guideline8 days
PM10112 µg/m³
Optical depth0.37
78910111213141516171819
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 86Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Frequently asked questions

How long did the Babanusa fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 8 November 2025 to 16 November 2025 (9 days). The perimeter dates it from 9 November 2025 to 16 November 2025.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 5,862 hectares (58.6 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Babanusa (5,898 ha, 2.5 %).
What was the weather like?
During the fire the temperature reached 37.1 °C, humidity dropped to 11 % and gusts hit 47 km/h. The fire danger index (FWI) reached 59, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Sudan (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Start date: 9 November 2025 → 8 November 2025.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery; 2 polygons grouped in this page.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 9 November 2025 to 16 November 2025. 86 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.