Skip to content
worldfires
MX · Mexico · –

Ayutla de los Libres fire, 4 May 2020 Ayutla de los Libres

Out · last detection 12 May 2020, 19:10 UTC

The fire started on 4 May 2020 in Ayutla de los Libres, Mexico, and satellites saw it burning for 11 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,664 hectares from heat detections, spread across a single municipality.

It is the 522th largest in Guerrero since 2016 (of 582 with a page). Number 208 in Mexico in 2020, of 241.

The power measured by the satellite is low (13.5 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,664ha
GWIS perimeter (Copernicus)
Duration
11days
4 May 2020 – 14 May 2020
Municipalities hit
1
municipalities
Started on
4 May
2020
Heat detections
60
in a single hotspot: 14 MW
Danger at start
31
High · FWI index
Average daily power
26MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 4 May14 May
12 May 2020

How it evolved, day by day

4 May 2020 · 114 MW · 16 5 May 2020 · 7 MW · 4 6 May 2020 · 44 MW · 24 7 May 2020 · 11 MW · 3 8 May 2020 · 4 MW · 4 9 May 2020 · 2 MW · 2 11 May 2020 · 14 MW · 2 12 May 2020 · 15 MW · 5
4 May 6 May 8 May 11 May

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

33°high
44km/h · peak gust
29%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 1.1% of the area of London (17 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Ayutla de los Libres where it started
    1,672 ha reached on 4 May
    1.6 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
4 May 32.8 °C 35 % 40 km/h 0.0 mm High 31
5 May 31.7 °C 29 % 40 km/h 0.0 mm High 36
6 May 31.3 °C 30 % 44 km/h 0.0 mm Very high 39
7 May 30.7 °C 41 % 35 km/h 1.1 mm High 27
8 May 32.6 °C 33 % 43 km/h 0.9 mm High 32
9 May 31.7 °C 36 % 40 km/h 0.4 mm High 33
10 May 32.6 °C 33 % 36 km/h 0.7 mm High 36
11 May 31.2 °C 41 % 35 km/h 0.1 mm High 24
12 May 32.3 °C 33 % 42 km/h 0.2 mm High 36
13 May 31.5 °C 38 % 41 km/h 0.9 mm High 37
14 May 31.7 °C 37 % 37 km/h 0.0 mm High 30
15 May after 31.9 °C 30 % 37 km/h 0.0 mm Very high 38
16 May after 32.6 °C 33 % 38 km/h 0.0 mm Very high 39
17 May after 33.7 °C 32 % 39 km/h 0.0 mm High 38
18 May after 32.4 °C 35 % 37 km/h 0.0 mm Very high 40
19 May after 33.0 °C 33 % 38 km/h 0.0 mm Very high 40
20 May after 31.6 °C 38 % 40 km/h 0.0 mm Very high 39
21 May after 30.4 °C 39 % 38 km/h 0.0 mm Very high 38
22 May after 32.3 °C 34 % 39 km/h 0.0 mm High 37
23 May after 30.3 °C 50 % 37 km/h 0.0 mm High 30
24 May after 32.2 °C 38 % 37 km/h 0.0 mm High 33

Its twins: fires that started in the same weather

It started with an FWI of 30.9, a minimum humidity of 35% and 2 days without rain. Fires in the area that started in weather like this since 2016: 26.

FWI at the start 30.9
Minimum humidity 35 %
Days without rain 2
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

San Luis Acatlán fire, May 2023
1,738 ha 10 days FWI 32.3 Min. humidity 34 % 7 km away, in 2023

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

10 days
median duration
2,142 ha
median area
100 %
went past 1,000 ha
1.8 mm
rain at the end (median; 22 of 26 had it)

It burned an area similar to its twins (1,664 ha against a median of 2,142 ha) and lasted 11 days, against 10 days.

In 4 of 26, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.8 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
44km/h · max. gust

It was considered over on 14 May, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 22 of 26, with a median of 1.8 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Apr 2020
After · 21 May 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 60Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Mexico

Frequently asked questions

How long did the Ayutla de los Libres fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 4 May 2020 to 14 May 2020 (11 days). The perimeter dates it from 4 May 2020 to 9 May 2020.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,664 hectares (16.6 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Ayutla de los Libres (1,672 ha, 1.6 %).
What was the weather like?
During the fire the temperature reached 32.8 °C, humidity dropped to 29 % and gusts hit 44 km/h. The fire danger index (FWI) reached 39, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 26. Their median duration was 10 days and their median area 2,142 ha; 100 % went past 1,000 ha. In 4 of 26, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.8 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 9 May 2020 → 14 May 2020.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 4 May 2020 to 9 May 2020. 60 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.