Skip to content
worldfires
en
UA · Ukraine ·

Antratsyt fire, 31 August 2026 Антрацитівський район · Antratsyt

Out · last detection 31 Aug 2026, 10:02 UTC

The fire started on 31 August 2026 in Antratsyt, Ukraine, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 156 hectares from satellite imagery, spread across a single municipality.

It is the 580th largest in Luhansk Oblast since 2016 (of 909 with a page). Number 606 in Ukraine in 2026, of 984.

The power measured by the satellite is low (14.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Suggestions: Kreminna · 2026Starobesheve · 2024Antratsyt · 2024Antratsyt · 2024

Burnt area
156ha
Copernicus perimeter
Duration
≈ 1day
31 Aug 2026 – 31 Aug 2026
Municipalities hit
1
districts
Started on
31 Aug
2026
Heat detections
6
in a single hotspot: 14 MW
Danger at start
33
High · FWI index
Average daily power
76MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 31 Aug31 Aug

How it evolved, day by day

31 Aug 2026 · 76 MW · 6

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

26°high
31km/h · peak gust
18%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started. Rain came after the fire: 9.6 mm on 6 Sept.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Antratsyt Антрацитівський район 30,070 inhabitants · 22.0 km from the centre where it started
    157 ha reached on 31 Aug
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas92 %
  • Mixed forest5.1 %
  • Other natural land2.6 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
31 Aug 26.2 °C 18 % 31 km/h 0.0 mm High 33
1 Sept after 27.1 °C 17 % 28 km/h 0.0 mm High 34
2 Sept after 28.6 °C 22 % 26 km/h 0.0 mm High 34
3 Sept after 27.1 °C 34 % 25 km/h 0.0 mm High 30
4 Sept after 26.8 °C 28 % 20 km/h 0.0 mm High 28
5 Sept after 28.2 °C 27 % 46 km/h 0.0 mm Very high 40
6 Sept after 22.3 °C 39 % 36 km/h 9.6 mm Very low 5

Its twins: fires that started in the same weather

It started with an FWI of 33.0, a minimum humidity of 18% and 2 days without rain. Fires in the area that started in weather like this since 2016: 25.

FWI at the start 33.0
Minimum humidity 18 %
Days without rain 2
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Kreminna fire, July 2026
188 ha 2 days FWI 34.0 Min. humidity 18 % 87 km away, in 2026

First rain (1 mm or more) after it ended: 8.7 mm on 5 Jul.

See its page Compare with this fire

What happened to them

2 days
median duration
232 ha
median area
16 %
went past 1,000 ha
2.7 mm
rain at the end (median; 19 of 25 had it)

It burned an area similar to its twins (156 ha against a median of 232 ha) and lasted 1 day, against 2 days.

In 6 of 25, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.7 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

9.6 mmfirst rain
6 Sept6 days after it ended
31km/h · max. gust

It was considered over on 31 Aug, and on 6 Sept 9.6 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 19 of 25, with a median of 2.7 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 24 Aug 2026
After · 7 Sept 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 2 September 2026 the air beside the fire reached 17 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak17 µg/m³
Days over the guideline0 days
PM1043 µg/m³
Optical depth0.29
29 Aug31 Aug2 Sept
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 6Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine

Frequently asked questions

How long did the Antratsyt fire last?
The official perimeter only gives the start date (31 August 2026). The end comes from the heat detections inside the perimeter: it burned until 31 August 2026 (1 day from 31 August 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 156 hectares (1.6 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Antratsyt (157 ha, 0.1 %).
Did the fire reach a town?
The fire started in Antratsyt and came within 22.0 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 26.2 °C, humidity dropped to 18 % and gusts hit 31 km/h. The fire danger index (FWI) reached 33, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 25. Their median duration was 2 days and their median area 232 ha; 16 % went past 1,000 ha. In 6 of 25, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.7 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 6 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.