Skip to content
worldfires
DZ · Algeria · →

Annaba fire, August 2026 عنابة · Seraidi, Annaba

Out · last detection 6 Sept 2026, 13:08 UTC

The fire started on 27 August 2026 in Annaba, Algeria, and satellites saw it burning for 11 days. Copernicus mapped a burnt perimeter of 543 hectares from satellite imagery, spread across 2 municipalities.

It is the 38th largest in El Tarf since 2016 (of 121 with a page). Number 81 in Algeria in 2026, of 197.

Burnt area
543ha
Copernicus perimeter
Duration
11days
27 Aug 2026 – 6 Sept 2026
Municipalities hit
2
communes
Started on
27 Aug
2026
Heat detections
77
in a single hotspot: 743 MW
Danger at start
55
Extreme · FWI index
Energy released
2.8GW
sum of detected power

Where it burned

6 Sept 2026
HOTSPOTS BY DAY 27 Aug6 Sept

How it evolved, day by day

27286

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

47°high
35km/h · peak gust
11%lowest humidity

It had gone 11 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Seraidi وادي العنب 21,088 inhabitants · 19.2 km from the town
    527 ha reached on 27 Aug
    3.9 %
  2. Annaba عنابة 257,359 inhabitants · 5.3 km from the town where it started
    17 ha reached on 27 Aug
    0.4 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Mixed forest53 %
  • Other natural land42 %
  • Broadleaved forest3.0 %
  • Agricultural areas1.3 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
27 Aug 46.7 °C 11 % 35 km/h 0.0 mm Extreme 55
28 Aug 35.0 °C 29 % 39 km/h 0.0 mm Very high 39
29 Aug 43.0 °C 21 % 55 km/h 0.4 mm Very high 44
30 Aug 32.4 °C 57 % 34 km/h 0.0 mm High 26
31 Aug 32.2 °C 51 % 34 km/h 0.0 mm High 26
1 Sept 34.2 °C 42 % 28 km/h 0.0 mm High 26
2 Sept 34.7 °C 50 % 36 km/h 0.0 mm High 26
3 Sept 33.7 °C 44 % 32 km/h 0.0 mm High 27
4 Sept 31.7 °C 50 % 36 km/h 0.0 mm High 28
5 Sept 31.1 °C 52 % 27 km/h 0.0 mm High 25
6 Sept 32.4 °C 44 % 30 km/h 0.0 mm High 26

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 20 Aug 2026
After · 13 Sept 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 30 August 2026 the air beside the fire reached 347 µg/m³ of PM2.5. That day averaged 135: 9.0 times the WHO daily guideline (15).

PM2.5 peak347 µg/m³
Days over the guideline5 days
PM10481 µg/m³
Optical depth3.08
252627282930
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 77Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Annaba fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 27 August 2026 to 6 September 2026 (11 days). The perimeter dates it from 27 August 2026 to 27 August 2026.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 543 hectares (5.4 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Seraidi (527 ha, 3.9 %); Annaba (17 ha, 0.4 %).
Did the fire reach a town?
The closest fire to a town centre came within 5.3 km of Annaba. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 46.7 °C, humidity dropped to 11 % and gusts hit 35 km/h. The fire danger index (FWI) reached 55, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.