Skip to content
worldfires
MG · Madagascar · –

Ambato Boeni fire, October 2026 Mitsinjo, Ambato Boeni, Marovoay

Out · last detection 21 Oct 2026, 10:47 UTC

Satellites first detected fire on 15 October 2026 in Ambato Boeni, Madagascar. It was active for 10 days, with 183 heat detections and an area with fire of about 2,212 hectares rebuilt from them, spread across 4 municipalities.

GWIS near-real-time perimeter, from the layer that changed in August 2025: this fire is not compared with fires from earlier years, because since then the GWIS layer gives more and larger perimeters.

GWIS (Copernicus) has not yet published the perimeter of this fire. It rebuilds it from hotspots, which can take several days, and it does not always arrive. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). If the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 2,212ha
rebuilt from hotspots, no official perimeter yet
Duration
10days
15 Oct 2026 – 24 Oct 2026
Municipalities hit
4
districts
Started on
15 Oct
2026
Heat detections
183
in a single hotspot: 63 MW
Danger at start
50
Extreme · FWI index
Average daily power
22MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 15 Oct24 Oct
21 Oct 2026

How it evolved, day by day

15 Oct 2026 · 11 MW · 1 16 Oct 2026 · 33 MW · 4 17 Oct 2026 · 0 MW · 0 18 Oct 2026 · 0 MW · 0 21 Oct 2026 · 0 MW · 0
15 Oct 16 Oct 17 Oct 18 Oct 21 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
42km/h · peak gust
26%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started. Rain came after the fire: 2.8 mm on 25 Oct.

What happened to each town

  1. 1,288 ha reached on 16 Oct
    0.3 %
  2. Ambato Boeni where it started
    700 ha reached on 15 Oct
    0.1 %
  3. 196 ha reached on 16 Oct
    0.0 %
  4. 28 ha reached on 17 Oct
    0.0 %

Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 7.0 % of the area in Madagascar

Day High Min. humidity Peak gust Rain Danger (FWI)
15 Oct 34.9 °C 27 % 37 km/h 0.1 mm Extreme 50
16 Oct 34.1 °C 26 % 39 km/h 0.2 mm Very high 49
17 Oct 33.9 °C 29 % 42 km/h 0.0 mm Extreme 53
18 Oct 34.4 °C 27 % 34 km/h 0.0 mm Very high 47
19 Oct 34.8 °C 32 % 26 km/h 0.0 mm Very high 41
20 Oct 35.8 °C 30 % 28 km/h 0.0 mm Very high 39
21 Oct 35.3 °C 37 % 35 km/h 0.0 mm Very high 38
22 Oct 35.7 °C 41 % 30 km/h 0.3 mm High 35
23 Oct 35.6 °C 44 % 34 km/h 0.1 mm High 32
24 Oct 37.8 °C 32 % 28 km/h 2.5 mm High 32
25 Oct after 36.1 °C 38 % 38 km/h 2.8 mm High 26

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 8 Oct 2026
After · 31 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 19 October 2026 the air beside the fire reached 71 µg/m³ of PM2.5. That day averaged 31: 2.1 times the WHO daily guideline (15).

PM2.5 peak71 µg/m³
Days over the guideline7 days
PM1076 µg/m³
Optical depth0.89
13 Oct16 Oct19 Oct22 Oct25 Oct
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 183Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Madagascar

Frequently asked questions

How long did the Ambato Boeni fire last?
According to the heat detections seen by satellite, it burned from 15 October 2026 to 24 October 2026 (10 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no perimeter yet. Heat detections rebuild about 2,212 hectares with fire (22.1 km²), a rough figure; GWIS will give its own when it publishes the perimeter, which can take several days.
Which municipalities burned?
The fire entered 4 municipalities: Mitsinjo (1,288 ha, 0.3 %); Ambato Boeni (700 ha, 0.1 %); Marovoay (196 ha, 0.0 %); Soalala (28 ha, 0.0 %).
Is the Ambato Boeni fire still active?
No fire detections since 21 Oct 2026, 10:47 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 37.8 °C, humidity dropped to 26 % and gusts hit 42 km/h. The fire danger index (FWI) reached 53, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Madagascar (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 26 October 2026.
  1. Page published (≈ 2,212 ha).

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • No perimeter yet: the area (≈ 2,212 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 183 Suomi-NPP VIIRS detections on those dates.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.