Skip to content
worldfires
SD · Sudan · –

Al Meiram fire, November 2026 Al Meiram, Abyei PCA area

Burning · last detection 20 Nov 2026, 12:16 UTC

Satellites first detected fire on 10 November 2026 in Al Meiram, Sudan. It has been active for 10 days, with 180 heat detections and an area with fire of about 2,296 hectares rebuilt from them, spread across 2 municipalities.

GWIS near-real-time perimeter, from the layer that changed in August 2025: this fire is not compared with fires from earlier years, because since then the GWIS layer gives more and larger perimeters.

GWIS (Copernicus) has not yet published the perimeter of this fire. It rebuilds it from hotspots, which can take several days, and it does not always arrive. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). If the perimeter arrives, this page picks it up on its own and keeps the same address.

Is it still active?

Satellites detected fire on 20 Nov 2026, 12:16 UTC. Everything suggests it is still burning. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Wind, humidity and rain for the next 72 h

Area with fire
≈ 2,296ha
rebuilt from hotspots, no official perimeter yet
Duration
10days
10 Nov 2026 – 19 Nov 2026
Municipalities hit
2
localities
Started on
10 Nov
2026
Heat detections
180
in a single hotspot: 36 MW
Danger at start
81
Very extreme · FWI index
Average daily power
293MW
detected power per day, on average

The next 72 hours

The wind is blowing from the north and pushing southwards; no sharp shifts are expected until Mon 23, 18:00.

ECMWF IFS 0.25° at the centre of the fire · computed 20 Nov 2026, 16:22 UTC

Fri 20, 20:00 – Sat 21, 07:00, local time

No overnight recovery: humidity stays at or below 23 %

Nights usually moisten the vegetation and the fire calms down. Tonight humidity does not reach 55 %, so it may stay active in the small hours.

Sat 21, 20:00 – Sun 22, 07:00, local time

No overnight recovery: humidity stays at or below 28 %

Nights usually moisten the vegetation and the fire calms down. Tonight humidity does not reach 55 %, so it may stay active in the small hours.

Sun 22, 20:00 – Mon 23, 07:00, local time

No overnight recovery: humidity stays at or below 31 %

Nights usually moisten the vegetation and the fire calms down. Tonight humidity does not reach 55 %, so it may stay active in the small hours.

Checked, no warning: no wind shifts of more than 60° no useful rain expected (0.0 mm in 72 h)

Hour by hour, local time

Tap the strip to see each hour

Mean wind Gusts where it blows to Relative humidity Night (8 pm to 8 am) Rain (mm) · chance in %

Where is it blowing? The next 48 h

geoBoundaries/South Sudan Information Management Working Group (IMWG), National Bureau of Statistics (NBS), and OCHA, OCHA South Sudan (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)); geoBoundaries/OCHA ROSEA, Information Management Working Group (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO))

At this hour

Places the fan reaches

    Is it heading my way?

    We compare your point with the fan for each hour. Your location never leaves your device.

    or tap the map

    This is not an official warning. It is a global model forecast with cells of about 25 km, at the centre of the fire: it cannot see valley winds or the winds the fire itself creates. The fan shows where the wind blows, not where the fire will spread. If in doubt, follow what the authorities say.

    Forecast: ECMWF IFS 0.25° (European Centre for Medium-Range Weather Forecasts), served by our own Open-Meteo instance; the chance of rain comes from the ECMWF ensemble. Variables: wind and gusts at 10 m, wind at 850 hPa, relative humidity and temperature at 2 m, rain. Open-Meteo.com (CC BY 4.0).

    Fire: VIIRS (NASA FIRMS); hotspots from the last 24 h: VIIRS from NASA FIRMS. Boundaries: geoBoundaries/South Sudan Information Management Working Group (IMWG), National Bureau of Statistics (NBS), and OCHA, OCHA South Sudan (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)); geoBoundaries/OCHA ROSEA, Information Management Working Group (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)).

    How it is worked out: wind shift = a change of more than 60° in 6 h or less, with at least 15 km/h before and after; no overnight recovery = peak humidity between 8 pm and 8 am stays below 55 %; useful rain = 2 mm or more in 6 h. The fan opens 18° plus however much the wind varies within ±3 h and reaches 25 km beyond the edge of the fire: one model cell, not a rate of spread. Methodology

    Where it burned

    HOTSPOTS BY DAY 10 Nov19 Nov
    20 Nov 2026

    How it evolved, day by day

    10 Nov 2026 · 670 MW · 84 11 Nov 2026 · 154 MW · 33 12 Nov 2026 · 414 MW · 46 13 Nov 2026 · 629 MW · 49 14 Nov 2026 · 361 MW · 32 15 Nov 2026 · 254 MW · 30 16 Nov 2026 · 165 MW · 28 17 Nov 2026 · 79 MW · 10 18 Nov 2026 · 210 MW · 28 19 Nov 2026 · 197 MW · 12 20 Nov 2026 · 92 MW · 10
    10 Nov 13 Nov 16 Nov 19 Nov

    Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

    Fire front film How it spread from one satellite pass to the next (38 passes) and with what wind. Watch the film

    The weather it burned in

    39°high
    40km/h · peak gust
    8%lowest humidity

    It had gone 29 days without rain (1 mm or more) when it started.

    What happened to each town

    1. 1,428 ha reached on 10 Nov
      0.3 %
    2. Abyei PCA area where it started
      854 ha reached on 10 Nov
      0.1 %

    Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

    The weather day by day

    ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

    Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

    Started with Extreme FWI: 79 % of the area in Sudan Very dry air: 55 % of the area in Sudan

    Day High Min. humidity Peak gust Rain Danger (FWI)
    10 Nov 35.8 °C 8 % 38 km/h 0.0 mm Very extreme 81
    11 Nov 34.9 °C 10 % 35 km/h 0.0 mm Very extreme 71
    12 Nov 35.4 °C 11 % 32 km/h 0.0 mm Extreme 67
    13 Nov 36.9 °C 11 % 30 km/h 0.0 mm Extreme 69
    14 Nov 37.6 °C 10 % 30 km/h 0.0 mm Very extreme 72
    15 Nov 38.7 °C 14 % 30 km/h 0.0 mm Very extreme 75
    16 Nov 39.3 °C 16 % 40 km/h 0.0 mm Very extreme 88
    17 Nov 38.7 °C 14 % 37 km/h 0.0 mm Very extreme 85
    18 Nov 38.7 °C 13 % 34 km/h 0.0 mm Very extreme 76
    19 Nov 37.9 °C 13 % 31 km/h 0.0 mm Very extreme 72
    20 Nov after 38.6 °C 14 % 31 km/h 0.0 mm Very extreme 72

    Before and after, from space

    Drag the line to compare the same ground before the fire and after it.

    Before · 3 Nov 2026
    After · 19 Nov 2026

    If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

    The smoke

    CAMS · Copernicus

    On 30 October 2026 the air beside the fire reached 49 µg/m³ of PM2.5. That day averaged 40: 2.7 times the WHO daily guideline (15).

    PM2.5 peak49 µg/m³
    Days over the guideline11 days
    PM10162 µg/m³
    Optical depth0.85
    26 Oct29 Oct1 Nov4 Nov
    Good Fair Moderate Poor Very poor Extremely poor

    Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

    Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

    Detections table · 180Every satellite heat detection, one by one, with time, satellite, power and coordinates.
    ⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
    Date and timeSatelliteFRP (MW)LatLon

    Other fires nearby

    All fires in Sudan

    Frequently asked questions

    How long did the Al Meiram fire last?
    According to the heat detections seen by satellite, it burned from 10 November 2026 to 19 November 2026 (10 days between the first and the last detection). There is no perimeter yet to date it.
    How much area did it burn?
    There is no perimeter yet. Heat detections rebuild about 2,296 hectares with fire (23.0 km²), a rough figure; GWIS will give its own when it publishes the perimeter, which can take several days.
    Which municipalities burned?
    The fire entered 2 municipalities: Al Meiram (1,428 ha, 0.3 %); Abyei PCA area (854 ha, 0.1 %).
    Is the Al Meiram fire still active?
    Yes: satellites detected fire on 20 Nov 2026, 12:16 UTC. Check the emergency service for the official status.
    What was the weather like?
    During the fire the temperature reached 39.3 °C, humidity dropped to 8 % and gusts hit 40 km/h. The fire danger index (FWI) reached 88, class Very extreme.
    What weather is expected at the fire over the next 72 hours?
    The wind is blowing from the north and pushing southwards; no sharp shifts are expected until Mon 23, 18:00. No overnight recovery: humidity stays at or below 23 % (Fri 20, 20:00 – Sat 21, 07:00). No overnight recovery: humidity stays at or below 28 % (Sat 21, 20:00 – Sun 22, 07:00). No overnight recovery: humidity stays at or below 31 % (Sun 22, 20:00 – Mon 23, 07:00). Times are local time at the fire. ECMWF IFS forecast (Open-Meteo) computed 20 Nov 2026, 16:22 UTC; this is not an official warning.
    Where does this data come from?
    From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Sudan (geoBoundaries). It is not an official report.

    Where to verify it

    A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

    Satellite cross-check

    History of this page · 7 Changes in area, dates, name, official record or merged pages, compared every night since 7 November 2026.
    1. Area: ≈ 2,492 → ≈ 2,296 ha.
    2. Start date: 8 November 2026 → 10 November 2026.
    3. Last day with fire: 6 November 2026 → 16 November 2026.
    4. Area: ≈ 2,002 → ≈ 2,492 ha.
    5. Start date: 28 October 2026 → 8 November 2026.
    6. Name: Abyei PCA area → Al Meiram.
    7. Page published (≈ 2,002 ha).

    RSS Changes to this page With cross-checks and a citable version

    Does something look wrong on this page?

    This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

    Report an error
    What do you think is wrong?

    We will only use your email to reply about this report. Privacy.

    How we know this
    • No perimeter yet: the area (≈ 2,296 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
    • Dates of the first and last VIIRS detection of the cluster. 180 Suomi-NPP VIIRS detections on those dates.
    • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

    How we build fire pages: methodology

    Where this data comes from

    The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.