Skip to content
worldfires
TD · Chad · →

Aboudéia fire, 15 December 2025 Aboudéia, Mangalmé

Out · last detection 24 Dec 2025, 11:13 UTC

The fire started on 15 December 2025 in Aboudéia, Chad, and satellites saw it burning for 12 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,565 hectares from heat detections, spread across 2 municipalities.

It is the 319th largest in Salamat since 2016 (of 579 with a page). Number 178 in Chad in 2025, of 274.

The power measured by the satellite is low (18.1 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Suggestions: Aboudéia · 2019

Burnt area
2,565ha
GWIS perimeter (Copernicus)
Duration
12days
15 Dec 2025 – 26 Dec 2025
Municipalities hit
2
departments
Started on
15 Dec
2025
Heat detections
35
in a single hotspot: 18 MW
Danger at start
55
Extreme · FWI index
Average daily power
47MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 15 Dec26 Dec
24 Dec 2025

How it evolved, day by day

18 Dec 2025 · 27 MW · 6 19 Dec 2025 · 69 MW · 6 20 Dec 2025 · 32 MW · 2 21 Dec 2025 · 26 MW · 5 22 Dec 2025 · 69 MW · 5 23 Dec 2025 · 91 MW · 9 24 Dec 2025 · 14 MW · 2
18 Dec 19 Dec 20 Dec 21 Dec 22 Dec 23 Dec 24 Dec

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
38km/h · peak gust
10%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 1.6% of the area of London (26 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Aboudéia where it started
    1,479 ha reached on 18 Dec
    0.1 %
  2. 1,103 ha reached on 19 Dec
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Dec 33.4 °C 13 % 38 km/h 0.0 mm Extreme 55
19 Dec 34.2 °C 13 % 34 km/h 0.0 mm Extreme 53
20 Dec 35.5 °C 13 % 25 km/h 0.0 mm Very high 47
21 Dec 36.4 °C 11 % 24 km/h 0.0 mm Very high 48
22 Dec 36.5 °C 11 % 19 km/h 0.0 mm Very high 49
23 Dec 37.2 °C 11 % 19 km/h 0.0 mm Very high 49
24 Dec 37.5 °C 10 % 23 km/h 0.0 mm Very high 50
25 Dec 37.8 °C 9 % 32 km/h 0.0 mm Extreme 55
26 Dec 37.9 °C 9 % 27 km/h 0.0 mm Extreme 51
27 Dec after 37.8 °C 9 % 28 km/h 0.0 mm Extreme 54
28 Dec after 37.2 °C 9 % 29 km/h 0.0 mm Extreme 54
29 Dec after 37.6 °C 10 % 32 km/h 0.0 mm Extreme 56
30 Dec after 37.1 °C 12 % 38 km/h 0.0 mm Extreme 62
31 Dec after 37.2 °C 11 % 28 km/h 0.0 mm Extreme 54
1 Jan after 37.7 °C 10 % 31 km/h 0.0 mm Extreme 56
2 Jan after 37.6 °C 9 % 28 km/h 0.0 mm Extreme 56
3 Jan after 37.1 °C 7 % 28 km/h 0.0 mm Extreme 58

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 8 Dec 2025
After · 2 Jan 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 16 December 2025 the air beside the fire reached 80 µg/m³ of PM2.5. That day averaged 49: 3.3 times the WHO daily guideline (15).

PM2.5 peak80 µg/m³
Days over the guideline7 days
PM10322 µg/m³
Optical depth0.28
161718192021222324252627
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 35Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Chad ›

Frequently asked questions

How long did the Aboudéia fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 15 December 2025 to 26 December 2025 (12 days). The perimeter dates it from 18 December 2025 to 24 December 2025.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,565 hectares (25.6 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Aboudéia (1,479 ha, 0.1 %); Mangalmé (1,103 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 37.5 °C, humidity dropped to 10 % and gusts hit 38 km/h. The fire danger index (FWI) reached 55, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Chad (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 24 December 2025 → 26 December 2025.
  2. Start date: 18 December 2025 → 15 December 2025.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 18 December 2025 to 24 December 2025. 35 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.