Skip to content
worldfires
US · United States · –

0658 Round Butte Fire, August 2026 Jefferson

Out · last detection 2 Aug 2026, 09:28 UTC

The fire started on 1 August 2026 in Jefferson, United States, and satellites saw it burning for 2 days. United States agencies (MTBS / NIFC) mapped an official burnt perimeter of 471 hectares, spread across a single county.

It is the 311th largest in Oregon since 2016 (of 325 with a page). Number 379 in United States in 2026, of 419.

The power measured by the satellite is low (1.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
471ha
official perimeter (MTBS / NIFC)
Duration
≈ 2days
1 Aug 2026 – 2 Aug 2026
Counties hit
1
counties
Started on
1 Aug
2026
Heat detections
4
in a single hotspot: 1 MW
Danger at start
62
Extreme · FWI index
Average daily power
5MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 1 Aug2 Aug

How it evolved, day by day

2 Aug 2026 · 5 MW · 4

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

29°high
45km/h · peak gust
18%lowest humidity

It had gone 16 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each county

  1. Jefferson where it started
    467 ha reached on 2 Aug
    0.1 %

Burnt area inside each county, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area0.16 ha
Residents< 20

Inside the perimeter there were about 0.16 hectares of built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 36 % of the area in United States

Day High Min. humidity Peak gust Rain Danger (FWI)
1 Aug 29.4 °C 20 % 45 km/h 0.0 mm Extreme 62
2 Aug 26.2 °C 18 % 41 km/h 0.0 mm Very high 47
3 Aug after 26.6 °C 22 % 33 km/h 0.0 mm Very high 46
4 Aug after 30.6 °C 15 % 31 km/h 0.0 mm Very high 43
5 Aug after 35.5 °C 7 % 26 km/h 0.0 mm Very high 44
6 Aug after 38.5 °C 3 % 29 km/h 0.0 mm Very high 47
7 Aug after 38.0 °C 9 % 39 km/h 0.0 mm Extreme 52
8 Aug after 35.4 °C 11 % 39 km/h 0.0 mm Extreme 59
9 Aug after 33.7 °C 11 % 42 km/h 0.0 mm Extreme 53
10 Aug after 32.6 °C 12 % 36 km/h 0.0 mm Extreme 55
11 Aug after 32.6 °C 18 % 41 km/h 0.0 mm Extreme 51
12 Aug after 30.3 °C 23 % 36 km/h 0.0 mm Extreme 51

Its twins: fires that started in the same weather

It started with an FWI of 61.8, a minimum humidity of 20% and 16 days without rain. Fires in the area that started in weather like this since 2016: 19.

FWI at the start 61.8
Minimum humidity 20 %
Days without rain 16
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Wiley Flat Fire, September 2024
12,249 ha 8 days FWI 62.6 Min. humidity 17 % 94 km away, in 2024

First rain (1 mm or more) after it ended: 4.6 mm on 11 Sept.

What happened to them

2 days
median duration
3,447 ha
median area
26 %
went past 10,000 ha
4.6 mm
rain at the end (median; 11 of 19 had it)

It stayed below its twins: 471 ha against a median of 3,447 ha. It lasted 2 days, against 2 days.

In 8 of 19, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 4.6 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
45km/h · max. gust

It was considered over on 2 Aug, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 11 of 19, with a median of 4.6 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 25 Jul 2026
After · 9 Aug 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 1 August 2026 the air beside the fire reached 219 µg/m³ of PM2.5. That day averaged 125: 8.4 times the WHO daily guideline (15).

PM2.5 peak219 µg/m³
Days over the guideline7 days
PM10221 µg/m³
Optical depth1.83
30 Jul1 Aug3 Aug5 Aug
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 4Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United States

Frequently asked questions

How long did the 0658 Round Butte Fire last?
The official perimeter only gives the start date (1 August 2026). The end comes from the heat detections inside the perimeter: it burned until 2 August 2026 (2 days from 1 August 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The official perimeter published by United States agencies (MTBS / NIFC) is 471 hectares (4.7 km²). Other tallies, such as daily incident reports, may give slightly different figures.
Which counties burned?
The fire only entered Jefferson (467 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 29.4 °C, humidity dropped to 18 % and gusts hit 45 km/h. The fire danger index (FWI) reached 62, class Extreme.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 19. Their median duration was 2 days and their median area 3,447 ha; 26 % went past 10,000 ha. In 8 of 19, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 4.6 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: NIFC WFIGS (United States), official.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 4 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.