Vardenis fire, 19 September 2017 Vardenis
The fire started on 19 September 2017 in Vardenis, Armenia, and satellites saw it burning for 1 day. Copernicus’s global GWIS system rebuilt a burnt perimeter of 331 hectares from heat detections, spread across a single municipality.
It is the 47th largest in Gegharkunik since 2016 (of 59 with a page). Number 24 in Armenia in 2017, of 30.
The power measured by the satellite is low (3.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.
Compare with…
- Burnt area
- 331ha
- GWIS perimeter (Copernicus)
- Duration
- 1day
- 19 Sept 2017 – 19 Sept 2017
- Municipalities hit
- 1
- municipalities
- Started on
- 19 Sept
- 2017
- Heat detections
- 12
- in a single hotspot: 3 MW
- Danger at start
- 19
- Moderate · FWI index
- Average daily power
- 31MW
- detected power per day, on average
Where it burned
How it evolved, day by day
19 Sept 2017 · 31 MW · 12
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
It had gone 2 days without rain (1 mm or more) when it started. Rain came after the fire: 5.4 mm on 25 Sept.
This area had burned before
No earlier perimeters overlap this fire since 2016, when the satellite record begins.
What happened to each town
-
Vardenis where it started330 ha0.3 %
Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
People and buildings inside the perimeter
GHSL 2015Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
| Day | High | Min. humidity | Peak gust | Rain | Danger (FWI) |
|---|---|---|---|---|---|
| 19 Sept | 21.1 °C | 25 % | 21 km/h | 0.0 mm | Moderate 19 |
| 20 Sept after | 21.7 °C | 24 % | 30 km/h | 0.0 mm | High 22 |
| 21 Sept after | 20.6 °C | 27 % | 35 km/h | 0.2 mm | High 24 |
| 22 Sept after | 20.8 °C | 26 % | 38 km/h | 0.4 mm | High 25 |
| 23 Sept after | 19.6 °C | 33 % | 36 km/h | 0.5 mm | High 24 |
| 24 Sept after | 18.6 °C | 40 % | 26 km/h | 0.3 mm | Moderate 19 |
| 25 Sept after | 15.6 °C | 53 % | 25 km/h | 5.4 mm | Very low 1 |
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
Detections table · 12Every satellite heat detection, one by one, with time, satellite, power and coordinates.
| Date and time | Satellite | FRP (MW) | Lat | Lon |
|---|
Other fires nearby
- 2,493 haMartuniOctober 2022 · 6 days · 12 km away
- 1,974 haKalbajar District14 November 2019 · 6 days · 24 km away
- 1,334 haKalbajar District24 October 2017 · 3 days · 24 km away
- 1,564 haVardenis29 September 2022 · 7 days · 25 km away
- 1,394 haKalbajar District13 September 2017 · 8 days · 26 km away
- 10,567 haKalbajar District2 September 2017 · 20 days · 37 km away
Frequently asked questions
- How long did the Vardenis fire last?
- GWIS (Copernicus) dates it between 19 September 2017 and 19 September 2017: 1 day between the first and last heat detection of the perimeter.
- How much area did it burn?
- The perimeter GWIS (Copernicus) rebuilt from heat detections is 331 hectares (3.3 km²). It is an estimate: official national figures may differ.
- Which municipalities burned?
- The fire only entered Vardenis (330 ha, 0.3 %).
- What was the weather like?
- During the fire the temperature reached 21.1 °C, humidity dropped to 25 % and gusts hit 21 km/h. The fire danger index (FWI) reached 19, class Moderate.
- Where does this data come from?
- From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Armenia (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
Emergency number: 911 · 112 · Emergency number and official warnings ›
Satellite cross-check
History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
No changes since 24 October 2026.
Does something look wrong on this page?
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
Report an error
How we know this
- Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
- Dates from the perimeter: the VIIRS detections inside it did not change them. 12 Suomi-NPP VIIRS detections on those dates.
- We have not matched this page with any official record.
- Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
- Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.
Where this data comes from
The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.