Skip to content
worldfires
TH · Thailand · →

Pha Khao fire, April 2026 Pha Khao, Phu Kradueng

Out · last detection 5 Apr 2026, 18:30 UTC

The fire started on 3 April 2026 in Pha Khao, Thailand, and satellites saw it burning for 4 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,071 hectares from heat detections, spread across 2 municipalities.

It is the 173th largest in Loei Province since 2016 (of 192 with a page). Number 805 in Thailand in 2026, of 880.

The power measured by the satellite is low (16.5 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,071ha
GWIS perimeter (Copernicus)
Duration
4days
3 Apr 2026 – 6 Apr 2026
Municipalities hit
2
districts
Started on
3 Apr
2026
Heat detections
18
in a single hotspot: 16 MW
Danger at start
29
High · FWI index
Energy released
80MW
sum of detected power

Where it burned

5 Apr 2026
HOTSPOTS BY DAY 3 Apr6 Apr

How it evolved, day by day

345

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
27km/h · peak gust
33%lowest humidity

It had gone 14 days without rain (1 mm or more) when it started.

This area had burned before

93% of the perimeter overlaps earlier fires recorded since 2016: 397 ha in 2016, 842 ha in 2017, 696 ha in 2019, 52 ha in 2020, 143 ha in 2021. Part of it burned more than once, so the yearly figures add up to more than the 992 ha that had burned before.

What happened to each town

  1. Pha Khao where it started
    957 ha reached on 3 Apr
    2.4 %
  2. 120 ha reached on 3 Apr
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Apr 37.6 °C 34 % 27 km/h 0.0 mm High 29
4 Apr 37.0 °C 36 % 24 km/h 0.0 mm High 29
5 Apr 37.1 °C 36 % 26 km/h 0.0 mm High 31
6 Apr 37.8 °C 33 % 25 km/h 0.0 mm High 31
7 Apr after 38.1 °C 31 % 25 km/h 0.0 mm High 33
8 Apr after 38.6 °C 29 % 27 km/h 0.0 mm High 34
9 Apr after 38.0 °C 30 % 30 km/h 0.0 mm High 35
10 Apr after 38.4 °C 28 % 28 km/h 0.0 mm High 34
11 Apr after 37.9 °C 27 % 33 km/h 0.0 mm High 37
12 Apr after 38.1 °C 30 % 26 km/h 0.0 mm High 34
13 Apr after 38.1 °C 31 % 25 km/h 0.0 mm High 34
14 Apr after 39.0 °C 27 % 23 km/h 0.0 mm High 35
15 Apr after 39.0 °C 27 % 27 km/h 0.0 mm High 36
16 Apr after 38.7 °C 28 % 25 km/h 0.0 mm High 35

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Mar 2026
After · 13 Apr 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 5 April 2026 the air beside the fire reached 64 µg/m³ of PM2.5. That day averaged 46: 3.1 times the WHO daily guideline (15).

PM2.5 peak64 µg/m³
Days over the guideline9 days
PM1079 µg/m³
Optical depth0.96
123456789
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 18Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Thailand ›

Frequently asked questions

How long did the Pha Khao fire last?
GWIS (Copernicus) dates it between 3 April 2026 and 6 April 2026: 4 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,071 hectares (10.7 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Pha Khao (957 ha, 2.4 %); Phu Kradueng (120 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 37.8 °C, humidity dropped to 33 % and gusts hit 27 km/h. The fire danger index (FWI) reached 31, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Thailand (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 199 · 191

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 199 · 191.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.