Skip to content
worldfires
ZM · Zambia · →

Nkeyema fire, 18 July 2026 Nkeyema

Out · last detection 22 Jul 2026, 12:14 UTC

The fire started on 18 July 2026 in Nkeyema, Zambia, and satellites saw it burning for 6 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,005 hectares from heat detections, spread across a single municipality.

It is the 161th largest in Western since 2016 (of 162 with a page). Number 608 in Zambia in 2026, of 610.

The power measured by the satellite is low (28.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
3,005ha
GWIS perimeter (Copernicus)
Duration
6days
18 Jul 2026 – 23 Jul 2026
Municipalities hit
1
districts
Started on
18 Jul
2026
Heat detections
41
in a single hotspot: 28 MW
Danger at start
39
Very high · FWI index
Energy released
522MW
sum of detected power

Where it burned

22 Jul 2026
HOTSPOTS BY DAY 18 Jul23 Jul

How it evolved, day by day

1819202122

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

28°high
36km/h · peak gust
13%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

23% of the perimeter overlaps earlier fires recorded since 2016: 305 ha in 2017, 93 ha in 2020, 424 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 694 ha that had burned before.

What happened to each town

  1. Nkeyema where it started
    3,022 ha reached on 17 Jul
    0.8 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Jul 26.0 °C 18 % 36 km/h 0.0 mm Very high 39
19 Jul 26.4 °C 13 % 34 km/h 0.0 mm Very high 42
20 Jul 27.2 °C 15 % 33 km/h 0.0 mm Very high 42
21 Jul 28.2 °C 13 % 29 km/h 0.0 mm Very high 42
22 Jul 28.0 °C 17 % 31 km/h 0.0 mm Very high 43
23 Jul 27.8 °C 22 % 30 km/h 0.0 mm Very high 42
24 Jul after 27.4 °C 22 % 37 km/h 0.0 mm Very high 46
25 Jul after 26.0 °C 23 % 49 km/h 0.0 mm Extreme 50
26 Jul after 24.5 °C 29 % 41 km/h 0.0 mm Very high 41
27 Jul after 24.7 °C 23 % 36 km/h 0.0 mm High 38
28 Jul after 26.0 °C 16 % 30 km/h 0.0 mm High 38
29 Jul after 27.2 °C 17 % 34 km/h 0.0 mm Very high 41
30 Jul after 27.3 °C 17 % 31 km/h 0.0 mm Very high 39
31 Jul after 26.9 °C 19 % 38 km/h 0.0 mm Very high 44
1 Aug after 25.4 °C 21 % 42 km/h 0.0 mm Very high 46
2 Aug after 24.7 °C 21 % 36 km/h 0.0 mm Very high 42

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Jul 2026
After · 30 Jul 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 19 July 2026 the air beside the fire reached 64 µg/m³ of PM2.5. That day averaged 40: 2.7 times the WHO daily guideline (15).

PM2.5 peak64 µg/m³
Days over the guideline10 days
PM1064 µg/m³
Optical depth0.38
1617181920212223242526
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 41Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Zambia ›

Frequently asked questions

How long did the Nkeyema fire last?
GWIS (Copernicus) dates it between 18 July 2026 and 23 July 2026: 6 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,005 hectares (30.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Nkeyema (3,022 ha, 0.8 %).
What was the weather like?
During the fire the temperature reached 28.2 °C, humidity dropped to 13 % and gusts hit 36 km/h. The fire danger index (FWI) reached 43, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Zambia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.